Table of Contents
Advertisement
Placement Options
To protect the cables attached to the Adapter's back
panel, snap the included cable hood into place. The
dark gray section of the cable hood faces away from
the antenna.
There are two ways to place the Adapter. The first way
is to place the Adapter horizontally on a surface, so it
sits on four small rubber feet.
The second way is to stand the Adapter vertically on a
surface (see Figure 7-3). To use the stand option, fol-
low these instructions:
1. The Adapter includes a base. Insert the end opposite to the antenna into the
base.
2. Snap the Adapter into the base, so it fits snugly.
3. Place the Adapter in an appropriate location, and if necessary, adjust the
antenna so that it points straight up in the air (see Figure 7-3).
If you have already set up the Adapter using the Setup Wizard, then pro-
ceed to "Chapter 8: Using the Media Navigator."
If you want to set up the Adapter from your TV, then proceed to the next
section, "Using the TV Setup."
26
Figure 7-3
Using the TV Setup
If you haven't already done so, insert the included AAA batteries into the
Remote Controller. For more information, see "Chapter 3: Getting to Know the
Wireless-B Media Adapter and Its Remote Controller."
To use the TV Setup to set up the Adapter, follow these instructions:
1. After you have connected the Adapter to your TV and stereo, connect the
included power adapter to the Power port of the Adapter.
2. Plug the power adapter into an electrical outlet.
3. When the message, "Please Wait", is displayed on your TV, press the Setup
button on the remote. Then the Media Adapter Setup screen will appear (see
Figure 7-4).
Figure 7-4
You have several settings to configure. To use the on-screen keyboard, press the
Select button on the Remote Controller to move from the settings down to the
keyboard. Then use the arrow buttons to move around the keyboard. To enter a
character, select the character, and press the Select button on the Remote
Controller. When you want to return to the settings, select the on-screen Enter
key, and press the Select button on the Remote Controller.
27
Advertisement
Table of Contents
