Contents Safety instructions Installation instructions Fitting under a counter Disposal Levelling Fitting a decor panel on the door Economical and ecological dishwashing Water supply connections Description of the appliance Water inlet hose with safety device Water outlet hose connection The control panel Electrical connection Prior to using for the first time Hints for test centres...
Safety instructions It is most important that this instruction book should be This product should be serviced by an authorised service retained with the appliance for future reference. Should engineer, and only genuine spare parts should be used. the appliance be sold or transferred to another owner, or Under no circumstances should you attempt to repair the should you move house and leave the appliance, always machine yourself.
Description of the appliance Upper basket stop Water hardness switch Salt container Detergent dispenser (Type A / Type B) Control panel Rating plate Rinse aid dispenser (Type A / Type B) Filters Lower spray arm 10. Upper spray arm 11. Upper basket 12.
Prior to using for the first time Before using your dishwasher for the first time: Setting electronically The dishwasher is factory set at level 3. If it’s necessary to set 1. Ensure that the electrical and water connections comply a new level, proceed as follows. with the installation instructions 2.
Filling with salt Rinse aid Rinse aid is automatically added during the last rinse, Special salt can be added in one of two ways: ensuring thorough rinsing, and spot and streak free drying. The dispenser, which is positioned inside the door, holds If you are using dishwasher detergent that already about 110 ml of rinse aid, which is sufficient for 16 - 40 contains salt, the detergent including the salt is placed in...
Filling with rinse aid To deactivate the rinse aid indicator (Rinse aid dispenser type B) light proceed as follows: (the dishwasher must be switched off) 1. Open the container by turning the lid (A) anticlockwise. 2. Add the rinse aid until the container is completely full. The 1.
In daily use Check if it’s necessary to refill with special salt or rinse aid When loading the dishes and cutlery, please note: - Dishes and cutlery must not impede the rotation of the Load cutlery and dishes into the dishwasher. spray arms .
In case that plates are loaded in the upper The cutlery basket basket: Long bladed knives stored in an upright position are a load them starting from the potential hazard. rear positions of the Long and/or sharp items of cutlery such as carving knives basket;...
Use of detergent Use of "3 in 1" combi detergent tablets Only use detergents specifically designed for use in General advice dishwashers. These products are tablets with combined detergent/rinse-aid Using no more then the correct amount of detergent and salt functions. contributes to reducing pollution.
The products In order to obtain a good wash, it is necessary to use detergents specially designed for dishwashers. To ensure that your dishwasher functions perfectly, Zanussi recommends using Calgonit System, a unique and complete product, tested by millions of householders.
Starting a washing programme 1. Check that the baskets have been 7. End of the washing programme loaded correctly and that the spray The dishwasher will automatically stop and the end of programme phase indicator light will illuminate. arms can rotate freely The indicator light of the programme just ended will remain on.
Maintenance and cleaning Clean the external surfaces of the machine and control panel To ensure a correct with a damp soft cloth. If necessary use only neutral working of the dishwasher, detergents. Never use abrasive products, scouring pads or NEVER try to remove the solvent (acetone, trichloroethylene etc..).
What to do, when... Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer..a flashing fault code appears The dishwasher will not start or stops during operation. All push buttons are inoperative except for the On/Off push button and a combination of indicator lights, as indicated in the following chart, are flashing.
...the wash results are not satisfactory The dishes are not clean The wrong washing programme has been selected. The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. The spray arms do not rotate freely due to wrong arrangement of the load.
Installation instructions Any electrical and/or plumbing work required to install Fitting a decor panel on the door this appliance should be carried out by a qualified The door of this machine has frames for fitting a plastic electrician and/or plumber or competent person. laminate decor panel in the colour required to match the Remove all packaging before positioning the machine.
Water supply connections Water outlet hose connection This dishwasher may be fed with either hot (max. 50°) or cold The end of the drain hose can be connected in the following water. Nevertheless we advise you a cold water supply. ways: A hot water supply is not always efficient with very soiled 1.
Important! Electrical connection The plug must still be accessible after the appliance has Information concerning the electrical connection is given on been installed. the rating plate on the edge of the dishwasher’s door on the In case that the electrical cable has to be replaced, please right.
Page 19
From the Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx.