Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document.
Safety information • Under no circumstances should you attempt In the interest of your safety and to ensure the to repair the machine yourself. Repairs car- correct use, before installing and first using the ried out by inexperienced persons will cause appliance, read this user manual carefully, in- injury or serious malfunctioning.
Installation or if the control panel, work top or plinth area are damaged such that the inside of the ap- • Check your dishwasher for any transport pliance is freely accessible. Contact your damage. Never connect a damaged ma- local Service Force centre, in order to avoid chine.
On/Off button Programme selection buttons Delay start button Indicator lights Digital display Function buttons • Press On/Off button, ALL programme selec- Setting mode tion button lights are illuminated = appliance IMPORTANT! in setting mode. Always remember that when performing opera- •...
Page 6
Programme selection buttons • Starting the washing programme: 1. Press the On/Off button. 2. Press the button corresponding to the required programme, the corresponding light remains illu- minated while the other programme lights turn off. In the digital display will appear, flashing, the run- ning time of the programme (in minutes).
Delay start button This option allows the start of the programme to be delayed from 1 to 19 hours. After having selected the washing programme press the delay start button until the flashing number of the hours for the delay start will appear in the digital display.
Washing programmes Programme Degree of soil Type of load Programme description Heavy soil Crockery, cutlery, pots Prewash and pans Main wash Intensive 70° 2 intermediate rinses Final rinse Drying A Auto 45° 70° Normal / Light soil. Crockery and cutlery Prewash Main wash 1 or 2 intermediate rinses...
the stated range for "Auto" programme (see adjusted between 45°C and 70°C depending "Washing programmes chart"). on the amount of soil on the dishes. During the "Auto" programme the temperature of the main wash water is also automatically First use •...
3. Press function button A, the lights of func- changes. (For the selection of the new level tion buttons B and C turn off while the light see the chart). of function button A goes on flashing. In the Examples: digital display is visible the current level.
IMPORTANT! Top up the special salt when the light on the control panel illuminates. Filling with rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close indicated by "max"...
Open the lid. Set the dosage level. (The Close the lid and press un- dose is factory set in po- til it locks. sition 4). Loading cutlery and dishes – Dishes and items of cutlery must not lie Sponges, household cloths and any object that inside one another, or cover each other.
Page 14
For washing in the dishwasher the following cutlery and dishes are not suitable: are of limited suitability: • Cutlery with wooden, horn, china or mother-of- • Only wash stoneware in the dishwasher if it is pearls handles. specially marked as being dishwasher-safe by the manufacturer.
Load cutlery. For best re- Place knives and other Load the lower basket. Arrange serving dishes and sults we recommend you items of cutlery with sharp large lids around the edge of the basket. to use the cutlery grid pro- points or edges with their vided (if the size and di- handles facing upwards.
Maximum height of the dishes in : upper basket lower basket With upper basket raised 20 cm 31 cm With upper basket lowered 24 cm 27 cm To move to the higher position proceed as follows: 1. Pull out the basket until it stops. 2.
Open the lid. Fill in the detergent in Observe the dosing lev- compartment A. els. For programmes with pre- When using detergent Close the lid. wash add an additional tablets: place detergent detergent dose in com- tablets in compartment A. partmentB.
Page 18
Once this function is selected it will remain ac- Activation/deactivation of the rinse aid tive also for the following washing programmes. dispenser With the selection of this function the inflow of 1. Press the On/Off button. The dishwasher rinse aid and salt from each respective supply must be in setting mode.
Unloading the dishwasher • Hot dishes are sensitive to knocks. • Water may appear on the sides and the door The dishes should therefore be allowed to of the dishwasher as the stainless steel will cool down before removing from the appli- eventually become cooler than the dishes.
Put the flat filter A back in Replace the filters and the base of the washing lock by turning the handle compartment and ensure clockwise to the stop. that it fits perfectly under the two guidesD. Cleaning the spray arms Prolonged periods of non- operation NEVER try to remove the spray arms.
3. Remove the water inlet and discharge ho- Avoid over tilting the machine during transpor- ses. tation. 4. Pull the machine out together with the ho- ses. Environmental concerns Packaging material The symbol on the product or on its pack- aging indicates that this product may not be The packaging materials are environmentally treated as household waste.
Page 22
Fault code and malfunction Possible cause and solution • The water tap is blocked or furred with limescale. appears in the digital display. Clean the water tap. The dishwasher does not fill with water. • The water tap is turned off. Turn the water tap on. •...
The wash results are not satisfactory The dishes are not clean • The wrong washing programme has been selected. • The dishes are arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded.
Noise level dB(A) Consumption values The consumption values are intended as a iations of the power supply and the amount of guide and depends on the pressure and the dishes. temperature of the water and also by the var- Consumption values Programme Programme duration (in Energy consumption (in...
Full load: 12 standard place settings Rinse aid setting position 4 (Type III) Upper basket Cutlery basket Lower basket cup racks: position A Installation (max. 60°) or cold water. Nevertheless we ad- WARNING! vise you a cold water supply. Any electrical and/or plumbing work required to install this appliance should be carried out by a WARNING! qualified electrician and/or plumber or compe-...
Water inlet hose with safety WARNING! The electrical cable for the safety valve is in the valve double-walled water inlet hose and is live. Connect the inlet hose to a water tap with an Therefore do not immerse the water inlet hose external thread of 3/4”.
be no smaller than the diameter of the hose If necessary, have the domestic wiring system provided. socket replaced. In case that the electrical ca- ble has to be replaced, contact your local Serv- Electrical connection ice Force centre. The plug must be accessible after the appliance CAUTION! has been installed.
Page 28
www.electrolux.com 156992070-00-29082007 Subject to change without notice...