Dial-In Setup Of Remote Phone; Deactivating Dial-Up Remote Phone; Web Portal Setup Of Remote Phone - Cisco 7960 User Manual
Ip phone
Hide thumbs
Also See for Cisco 7960:
- Administrator's manual (212 pages) ,
- User manual (179 pages) ,
- Administration manual (150 pages)
Table of Contents
Advertisement
Dial-in Setup of Remote Phone
Deactivating Dial-up Remote Phone
Web Portal Setup of Remote Phone
Cisco 7960/7940 Telephone User Guide
620-05600070B
Phone and advises you to hang up the phone and try again. Until you
hang up the phone and disconnect from the Remote Phone feature,
you will receive the announcement.
There are two ways to enable the Remote Phone feature:
•
by dialing a special DID number, or
•
through the Web Portal under Options > Remote
To set up a remote phone by dialing in, you must call using the remote phone where
your VoIP phone calls will be forwarded.
1.
From the remote phone (example, your cell phone or a hotel phone), dial the
Remote Phone access DID number.
Your service provider should have provided this number to you.
2.
Enter the phone number of your VoIP phone followed by the pound sign (#).
EXAMPLE: 9723353421# or 9723352100*2001# for Non-DID numbers.
3.
Enter the password for your VoIP phone followed by #.
4.
DO NOT hang up the destination phone. Leave it off-hook.
5.
If a call comes in, press star (*) to answer the call.
6.
Disconnect from a call by pressing "###", which will leave the Remote Phone
active (you will hear hold music playing).
NOTE: Be aware that if you are using a cell phone, the phone is still in an active call.
If you hang up the remote phone, it will disconnect the call and deactivate the
Remote Phone mode.
The remote phone feature can be activated via the Web Portal by selecting
Options > Remote. You must check the box labeled Enable Remote User, then
enter the phone number of the remote phone (for example, a cell phone or hotel
phone number).
Dial-in Setup of Remote Phone
System Telephone Features
73
Hide quick links:
Advertisement
Table of Contents
