Required Tools; Removing An Ac-Input Power Supply - Cisco CAtalyst 4500 Series Installation Manual
Hide thumbs
Also See for CAtalyst 4500 Series:
- Software configuration manual (2086 pages) ,
- Administration manual (1814 pages) ,
- Configuration manual (1610 pages)
Table of Contents
Advertisement
Chapter 4
Removing and Replacing FRUs
Required Tools
Removing an AC-Input Power Supply
Step 1
Step 2
78-14409-08
You will need a flathead or Phillips screwdriver to perform these procedures.
Follow these steps to remove the AC-input power supply:
Press the power switch on the AC-input power supply down to the off (O) position
(see
Figure
4-5).
Figure 4-5
Powering Off the Power Switch
Power switch
There are two on/off switches on a 4200 W AC power supply, one for each
Note
input.
Loosen the side-clamp screw on the right side of the power cord plug (see
Figure
4-6).
Removing and Replacing the Power Supply
Catalyst 4500 Series Switches Installation Guide
4-5
Advertisement
Table of Contents
Troubleshooting
