Install An External Non-Cisco Module; Tools And Materials You Supply; Open And Close The Router Door; Connect The Module To The Chassis - Cisco 1240 Hardware Installation Manual
Connected grid router
Hide thumbs
Also See for 1240:
- Configuration manual (40 pages) ,
- Design and deployment manual (184 pages) ,
- Hardware installation manual (90 pages)
Table of Contents
Advertisement
Install an External Non-Cisco Module
Install an External Non-Cisco Module
This section provides the information you need to connect an external, non-Cisco module to the router.
Some steps might require that you refer to the documentation that supports the module. This section
includes these installation topics:
•
•
•
•
•
•
Tools and Materials You Supply
•
•
•
The housing for any power connector adapter that you supply must comply with the UL 94 V-1
Caution
flammability standard.
Open and Close the Router Door
You might be required to open the router door to install the module. For instructions on opening and
closing the router door, see the
Connect the Module to the Chassis
The router front door has these features for installing a module on the router exterior:
•
•
To attach the module to the mounting bosses, you must:
•
•
Cisco 1240 Connected Grid Router Hardware Installation Guide
13-4
Tools and Materials You Supply, page 13-4
Open and Close the Router Door, page 13-4
Connect the Module to the Chassis, page 13-4
Cabling Instructions, page 13-6
Connect to the Network, page 13-8
Connect to Power, page 13-9
Wrench—You must supply a 13-mm box-end wrench or socket set to remove port plugs from the
cable ports and a 15/16-inch open-end wrench to install the cable glands on the cable ports.
Hardware—You must provide any hardware as required in the
section on page
13-4.
Power Connector Adapter—Depending on your module power cable, you might need to provide
an adapter to connect the module to the router 4-pin Micro-Fit 3.0 power connector.
Six mounting bosses for attaching a module to the router (see
Two cable ports to thread power and Ethernet cables to the router interior (see
Provide the hardware required to attach the module to the mounting bosses
Follow the mounting instructions that support the module
"Opening the Router Chassis"
Chapter 13
Installing External Non-Cisco Modules
"Connect the Module to the Chassis"
chapter.
in
Figure
13-1)
1
in
2
Figure
13-1)
OL-26223-04
Advertisement
Table of Contents
