Chapter 6
Installing the Router
•
Related Information
The
•
•
•
Connecting the IRIG-B Port
See
Currently not supported. This hardware feature will be supported in a future software release.
Note
About
The IRIG-B port provides precise time data. The source of the time is the GPS to which the router is
connected. This port provides time output only.
Connecting
•
•
•
Related Information
The
•
•
Installing Modules and Antennas
The router supports up to four Cisco Connected Grid modules. Each module requires one or two
antennas, which are installed on or near the router. See these chapters for more information:
•
•
OL-26223-04
When connecting this port to an external alarm system, you must use cable glands and thread cables
through the chassis cable ports on the router. See the
Ports" section on page 6-12
"Router Hardware Description"
Specifications
Location on the router
Link to pinout information
Figure 3-20
for the IRIG-B port location.
You can connect this port while the router is operating normally.
You must provide the device and the cable for this connection.
When connecting this port to an external device, you must use cable glands and thread cables
through the chassis cable ports on the router. See the
Ports" section on page 6-12
"Router Hardware Description"
Supported serial time code formats
Location on the router
"Connected Grid Modules"
"Antennas"
chapter
"External Connections and Chassis Cable
for more information.
chapter includes detailed information about this port, including:
"External Connections and Chassis Cable
for more information.
chapter includes detailed information about this port, including:
chapter
Cisco 1240 Connected Grid Router Hardware Installation Guide
Installing Modules and Antennas
6-23