Cooling System; Figure 1-32 Front System View Of Power Trays -Cisco Asr 9922 Router With Version 2 Power Trays - Cisco ASR 9001-S Overview And Reference Manual
Asr 9000 series aggregation services router
Hide thumbs
Also See for ASR 9001-S:
- Installation manual (284 pages) ,
- Manual (44 pages) ,
- Unpacking and installing (98 pages)
Table of Contents
Advertisement
Cooling System
•
•
Figure 1-32
Cisco ASR 9922 Router.
Figure 1-32
Cooling System
The Cisco ASR 9000 Series chassis is cooled by removable fan trays. The fan trays provide full
redundancy and maintain required cooling if a single fan failure should occur.
In the Cisco ASR 9010 Router, the two fan trays are located one above the other below the card cage and
are equipped with handles for easy removal.
In the Cisco ASR 9006 Router, the two fan trays are located above the card cage, left of center, and side
by side. They are covered by a fan tray door hinged at the bottom, which must be opened before removing
the fan trays.
In the Cisco ASR 9904 Router, a single fan tray is located in the rear, right side of the card cage and is
equipped with a handle for easy insertion.
In the Cisco ASR 9922 Router, the two top fan trays are located between the top and middle cages,
whereas the two bottom fan trays are located between the middle and bottom cages. The two bottom fan
trays are inserted upside down compared to the two top fan trays. In the Cisco ASR 9912 Router, the two
fan trays are located above the line card cage. Each fan tray holds 12 axial fans and includes a controller
that reduces the speed of the fans when the chassis temperature is within limits, thereby reducing the
generation of acoustic noise. The fan controller also senses and reports individual fan failures.
Cisco ASR 9000 Series Aggregation Services Router Overview and Reference Guide
1-36
To operate the Cisco ASR 9912 Router on AC power, three AC power trays should be installed, each
with up to four power modules which are fed by a single-phase 220-V 20-A branch circuit. Six
power modules are enough to power a fully-populated chassis. Twelve power modules are required
for N+N redundancy. Fewer power modules can be used if the chassis is populated with fewer line
cards.
To operate the Cisco ASR 9912 Router on DC power, three DC power trays should be installed, each
with up to four power modules which are fed by separate pairs of redundant –48-V 60A branch
sources. Eleven power modules are enough to power a fully-populated chassis. Twelve power
modules are required for N+1 redundancy. Fewer power modules can be used if the chassis is
populated with fewer line cards.
shows the front view of sixteen version 2 power modules installed in the
Front System View of Power Trays —Cisco ASR 9922 Router with Version 2 Power
Trays
Chapter 1
Overview and Physical Description
OL-17501-09
Hide quick links:
Advertisement
Table of Contents
