Table of Contents
Advertisement
Chapter
09
Customising the AV Source Setting
% Touch [Auto PI] in Initial menu.
Touching [Auto PI] switches between [On]
and [Off].
Setting the rear output and
subwoofer controller
This navigation system's rear output (rear
speaker leads output and RCA rear output)
can be used for full-range speaker
(Rear SP Full) or subwoofer (Rear SP Sub. W)
connection. If you switch the rear output set-
ting to Rear SP Sub. W, you can connect a
rear speaker lead directly to a subwoofer with-
out using an auxiliary amp. Initially, the navi-
gation system is set for rear full-range speaker
connection (Rear SP Full). When rear output is
connected to full-range speakers (when
Rear SP Full is selected), you can connect the
RCA subwoofer output to a subwoofer. In this
case, you can select whether to use the sub-
woofer controller's (low pass filter, phase)
built-in Preout Sub. W or the auxiliary
Preout Full.
1
Touch [Rear SP] in Initial menu.
2
Touch [Rear SP] to switch the rear out-
put setting.
When no subwoofer is connected to the rear
output, select Full.
When a subwoofer is connected to the rear
output, select Sub. W.
p When the rear output setting is Sub. W,
you cannot change the subwoofer control-
ler.
3
Touch [Preout] to switch the subwoofer
output or non fading output.
p Even if you change this setting, there is no
output unless you turn [Non Fading] or
[Sub Woofer] in Sound menu [On].
= For details, refer to Using non fading output
on page 119.
= For details, refer to Using subwoofer output
on page 119.
124
Engb
p If you change the subwoofer controller
(Rear SP), the subwoofer output
(Sub Woofer) and non fading output
(Non Fading) in Sound menu return to the
factory settings.
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting.
Editing the PIN code
You can edit the PIN code you like. Use this
function when you need to change the PIN
code from the default setting.
1
Touch [PIN Edit] in Initial menu.
2
Touch number key to enter the new PIN
code.
Bluetooth Device (BD) address
Version of the Bluetooth module
System (microprocessor) version
3
Touch [Enter] to fix the new PIN code.
p The default setting of the PIN code is 0000.
Switching the sound muting/
attenuation
Sound from this system is muted, attenuated
or mixed automatically in the following cases:
! When a call is made or received using a
mobile phone connected to navigation sys-
tem.
! When the voice guidance is output.
p The sound muting/attenuation function
does not work when you use a mobile
phone connected to the navigation system
via Bluetooth wireless technology.
PIN code
Advertisement
Table of Contents
