Cisco Catalyst 2960-XR Configuration Manual page 72
Switch interface and hardware component
Hide thumbs
Also See for Catalyst 2960-XR:
- Security configuration manual (404 pages) ,
- Configuration manual (196 pages) ,
- Configuration manuals (120 pages)
Table of Contents
Advertisement
Configuring LLDP Characteristics
SUMMARY STEPS
1. configure terminal
2. lldp holdtime seconds
3. lldp reinit delay
4. lldp timer rate
5. lldp tlv-select
6. interface interface-id
7. lldp med-tlv-select
8. end
9. show lldp
10. copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2
lldp holdtime seconds
Example:
Switch(config)# lldp holdtime 120
Step 3
lldp reinit delay
Example:
Switch(config)# lldp reinit 2
Step 4
lldp timer rate
Example:
Switch(config)# lldp timer 30
Step 5
lldp tlv-select
Example:
Switch(config)# tlv-select
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
60
Configuring LLDP, LLDP-MED, and Wired Location Service
Purpose
Enters global configuration mode.
(Optional) Specifies the amount of time a receiving device
should hold the information from your device before discarding
it.
The range is 0 to 65535 seconds; the default is 120 seconds.
(Optional) Specifies the delay time in seconds for LLDP to
initialize on an interface.
The range is 2 to 5 seconds; the default is 2 seconds.
(Optional) Sets the sending frequency of LLDP updates in
seconds.
The range is 5 to 65534 seconds; the default is 30 seconds.
(Optional) Specifies the LLDP TLVs to send or receive.
OL-29420-01
Advertisement
Table of Contents
