Cisco CB21AG Install Wizard page 18

Hide thumbs Also See for CB21AG:

Table of Contents

Installing or Upgrading Client Adapter Software

Figure 10

The installation process begins, and you are notified as each software component is installed.

When a message appears indicating that your computer needs to be rebooted, click OK and allow your

Step 26

computer to restart.

If the Windows Found New Hardware Wizard appears after your computer reboots, click Next, allow the

Step 27

wizard to install the software for the client adapter, and click Finish.

If your network setup does not include a DHCP server and you plan to use TCP/IP, follow these steps

Step 28

for your operating system.

Windows 2000

•

Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5

Setup Status Window

Double-click My Computer, Control Panel, and Network and Dial-up Connections.

Right-click Local Area Connection x (where x represents the number of the connection).

Click Properties.

In the Components Checked Are Used by This Connection field, click Internet Protocol

(TCP/IP) and Properties.

Choose Use the following IP address and enter the IP address, subnet mask, and default

gateway address of your computer (which can be obtained from your system administrator).

Click OK to close each open window.

OL-8008-01

Table of Contents

Pi21ag