Table of Contents
Advertisement
[2] AR-LC6 UNPACKING AND
INSTALLATION
1. Unpacking
(Removal of the main unit)
2. Installation
<Before installation>
• Packaged parts check
Check to insure that all the following parts are packaged.
• Check that the printer is in stand-by state.
Check that the DATA indicator on the operation panel is neither lit
nor blinking.
1
Parts included
1
Upper mounting plate
2
Lower front connecting plate
3
Lower rear connecting plate
4
Fixing screw A (M4 x 16 small screw bind uniqlo)
5
Fixing screw B (Hex washer S tight M4 x 12)
2
3
4
5
2pcs.
1pc.
1pc.
4pcs.
4pcs.
AR-M550/M620/M700 INSTALLATION MANUAL (AR-LC6) 2 - 1
A. Turn off the power of the main unit.
1) Turn OFF the power switch on the right side of the main unit.
2) Open the front cabinet, and turn OFF the main power switch.
3) Disconnect the power plug from the power outlet.
B. Attach the upper mounting plates and the lower
front/rear connecting plates.
1) Attach the two upper mounting plates with the rubber portion ( )
down to the right side of the main unit using screws A (two for
each).
2) Remove the fixing screw of the front/rear cover on the lower right
side of the main unit. Attach the lower front side (engraved mark F)
of the connecting plate to the lower front side of the main unit with
two fixing screws B.
Attach the lower rear side (engraved mark R) of the connecting
plate to the lower rear side of the main unit with two fixing screws
B.
- Quick Links:
- 6 ] Ar-P19 Installation
Hide quick links:
Advertisement
Table of Contents
