Configuring Dscp Maps; Configuring The Cos-To-Dscp Map - Cisco Catalyst 3120 Software Manual

Catalyst blade switch for hp

Hide thumbs Also See for Catalyst 3120:

Table of Contents

Configuring Standard QoS

Switch(config-pmap-c)# trust dscp

Switch(config-pmap-c)# police aggregate transmit1

Switch(config-pmap-c)# exit

Switch(config-pmap)# class ipclass2

Switch(config-pmap-c)# set dscp 56

Switch(config-pmap-c)# police aggregate transmit1

Switch(config-pmap-c)# exit

Switch(config-pmap)# exit

Switch(config)# interface gigabitethernet2/0/1

Switch(config-if)# service-policy input aggflow1

Switch(config-if)# exit

Configuring DSCP Maps

These sections contain this configuration information:

All the maps, except the DSCP-to-DSCP-mutation map, are globally defined and are applied to all ports.

You use the CoS-to-DSCP map to map CoS values in incoming packets to a DSCP value that QoS uses

internally to represent the priority of the traffic.

If these values are not appropriate for your network, you need to modify them.

Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide

Configuring the CoS-to-DSCP Map, page 36-60

Configuring the IP-Precedence-to-DSCP Map, page 36-61

Configuring the Policed-DSCP Map, page 36-62

not appropriate)

Configuring the DSCP-to-CoS Map, page 36-63

Configuring the DSCP-to-DSCP-Mutation Map, page 36-64

map are not appropriate)

shows the default CoS-to-DSCP map.

Default CoS-to-DSCP Map

(optional, unless the null settings in the map are

(optional, unless the null settings in the

Configuring QoS

Table of Contents