Recovering From A Lost Or Forgotten Password - Cisco Catalyst 3120 Software Manual
Catalyst blade switch for hp
Hide thumbs
Also See for Catalyst 3120:
- Command reference manual (982 pages) ,
- Hardware installation manual (76 pages) ,
- Manual (42 pages)
Table of Contents
Advertisement
Chapter 47
Troubleshooting
You can release the Mode button after the system LED stops blinking and is solid green. Several lines
of information about the software appear along with instructions:
The system has been interrupted prior to initializing the flash file system. The following
commands will initialize the flash file system, and finish loading the operating system
software#
flash_init
load_helper
boot
Initialize the flash file system:
Step 7
switch: flash_init
Step 8
If you had set the console port speed to anything other than 9600, it has been reset to that particular
speed. Change the emulation software line speed to match that of the switch console port.
Step 9
Load any helper files:
switch: load_helper
Step 10
Start the file transfer by using the Xmodem Protocol.
switch: copy xmodem: flash:image_filename.bin
Step 11
After the Xmodem request appears, use the appropriate command on the terminal-emulation software to
start the transfer and to copy the software image into flash memory.
Step 12
Boot up the newly downloaded Cisco IOS image.
switch:boot flash:image_filename.bin
Use the archive download-sw privileged EXEC command to download the software image to the switch
Step 13
or to the switch stack.
Use the reload privileged EXEC command to restart the switch and to verify that the new software image
Step 14
is operating properly.
Delete the flash:image_filename.bin file from the switch.
Step 15
Recovering from a Lost or Forgotten Password
The default configuration for the switch allows an end user with physical access to the switch to recover
from a lost password by interrupting the boot process during power-on and by entering a new password.
These recovery procedures require that you have physical access to the switch.
Note
On these switches, a system administrator can disable some of the functionality of this feature by
allowing an end user to reset a password only by agreeing to return to the default configuration. If you
are an end user trying to reset a password when password recovery has been disabled, a status message
shows this during the recovery process.
These sections describes how to recover a forgotten or lost switch password:
•
•
OL-12247-01
Procedure with Password Recovery Enabled, page 47-5
Procedure with Password Recovery Disabled, page 47-7
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
Recovering from a Lost or Forgotten Password
47-3
Advertisement
Chapters
Table of Contents
Troubleshooting
