Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZDTS102
Summary of Contents for Zanussi ZDTS102
- Page 1 User manual Dishwasher ZDTS102...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Select and start a washing programme _ _ _ _ _ 11 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11 Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 What to do if…... -
Page 3: Control Panel
• A qualified and competent person must do the elec- – if the control panel, worktop or plinth area are trical installation. damaged, that you can get access to the inner side of the appliance. • A qualified and competent person must do the Contact your local Service Force Centre. -
Page 4: Washing Programmes
Programme selection/cancel button • Deactivation/activation of the audible signals. Use the programme selection/cancel button for these Audible signals operations: You can hear an audible signal: • To set the washing programme. Refer to the chapter • At the end of the washing programme. 'Setting and starting a washing programme'. -
Page 5: Use Of The Appliance
Degree of Type of Programme Programme description soil load Prewash Crockery, Main wash up to 65°C Normal cutlery, pots 2 intermediate rinses soil and pans Final rinse Drying Main wash up to 65°C Normal or Crockery Final rinse light soil and cutlery Prewash Main wash up to 50°C... -
Page 6: Set The Water Softener
7. Start the washing programme. 'Use of detergent'. If you use detergent tablets, refer to the chapter Set the water softener The water softener removes minerals and salts from • mmol/l (millimol per litre - international unit for the the water supply. Minerals and salts can have bad ef- hardness of water). -
Page 7: Use Of Dishwasher Salt
3. Press and hold the programme selection/cancel – The setting function of the water softener is ac- button. tivated. 4. Release the programme selection/cancel button – The end indicator light flashes to show the level when programme indicator light A starts to flash of the water softener. -
Page 8: Load Cutlery And Dishes
Fill when the rinse aid in- dicator (B) becomes clear. Caution! Do not fill the rinse aid dispenser with other products (e.g. dishwasher cleaning agent, liquid detergent). There is a risk of damage to the appliance. Adjusting the dosage of rinse aid The rinse aid dial is set at the factory at position 4. -
Page 9: Use Of Detergent
Adjustment of the height of the upper basket If you put large plates in the lower basket, first move the upper basket to a upper position. Warning! Adjust the height before you load the upper basket. Maximum height of the dishes in : upper basket lower basket Upper position... - Page 10 Use of detergent tablets Put the detergent tablet in the detergent dispenser (A). Detergent tablets contain: • detergent • rinse aid • other cleaning agents. Do these steps to use detergent tablets: 1. Make sure that the detergent tablets are applicable Fill the detergent dis- If you use a washing pro- for your water hardness.
-
Page 11: Select And Start A Washing Programme
Select and start a washing programme 1. Switch off the appliance. Set the washing programme with the door ajar. The washing programme only starts after you 2. Set a new washing programme. close the door. Until then it is possible to modify the Fill the detergent dispenser with detergent before you settings. -
Page 12: What To Do If
Fully clean the filters A, B Put the filter system in and C below running wa- position. To lock the filter ter. system, turn the handle clockwise until it locks in position. Important! Do not remove the spray arms. If the holes in the spray arms become clogged, remove remaining parts of soil with a cocktail stick. - Page 13 Fault code and malfunction Possible cause and solution • continuous flash of the light of the • The water tap is blocked or furred with limescale. running programme Clean the water tap. • intermittent audible signal • The water tap is closed. Open the water tap.
-
Page 14: Technical Data
The cleaning results are not satisfactory Limescales particles on the • The salt container is empty. dishes • The water softener is adjusted on a wrong level. • The salt container cap is not closed correctly. The dishes are wet and dull •... -
Page 15: Water Connection
Make sure that the water inlet hose, the drain hose and Important! Obey the instructions in the enclosed the supply cable are not kinked or squashed, when you template to: insert the machine. • Build-in the appliance. Attaching the appliance to the adjacent units •... -
Page 16: Electrical Connection
Drain hose max 85 cm min 40 cm The internal diameter must not be smaller than the di- Connect the water drain ameter of the hose. hose to the sink spigot. If you connect the water drain hose to a trap spigot under the sink, remove the plastic membrane (A). - Page 20 www.electrolux.com 117957390-00-112008...