Page 3
or damaged power plug may overheat and cause a Care and cleaning fire. • Before maintenance, switch off the appliance and dis- 3. Make sure that you can come to the mains plug of connect the mains plug from the mains socket. the appliance.
Environment Protection insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations This appliance does not contain gasses which could to obtain from your local authorities. Avoid damaging the damage the ozone layer, in either its refrigerant cir- cooling unit, especially at the rear near the heat exchang- cuit or insulation materials.
Positioning the door shelves Important! In the event of accidental defrosting, for example due to a power failure, if the power has been off To permit storage of food for longer that the value shown in the technical packages of various sizes, characteristics chart under "rising time", the defrosted the door shelves can be food must be consumed quickly or cooked immediately...
Fruit and vegetables: these should be thoroughly cleaned • lean foods store better and longer than fatty ones; salt and placed in the special drawer(s) provided. reduces the storage life of food; Butter and cheese: these should be placed in special air- •...
Defrosting of the refrigerator 3. Leave the door open and insert the Frost is automatically eliminated from the evaporator of plastic scraper in the refrigerator compartment every time the motor com- the appropriate pressor stops, during normal use. The defrost water seating at the bot- drains out through a trough into a special container at the tom centre, placing...
Page 8
Problem Possible cause Solution The appliance does not operate. The appliance is switched off. Switch on the appliance. The lamp does not operate. The mains plug is not connected to the Connect the mains plug to the mains mains socket correctly. socket correctly.
Replacing the lamp power and specifically designed for household appli- ances (the maximum power is shown on the lamp Caution! Disconnect the plug from the mains cover). socket. 4. Install the lamp cover. 1. Remove the screw 5. Tighten the screw to the lamp cover. from the lamp cov- 6.
Page 10
1. Connect the wire coloured green and yellow to the Warning! This appliance must be earthed. terminal marked either with the letter “E“ or by the The manufacturer declines any liability should these earth symbol or coloured green and yellow. safety measures not be observed.
Page 11
Ventilation requirements Installing the appliance Caution! Make sure that the mains cable can move The airflow behind the ap- freely. pliance must be sufficient. min. 50 mm 200 cm Do the following steps: min. 200 cm 44mm If necessary cut the adhe- Install the appliance in the Adjust the appliance in the Attach the appliance to the...
Page 12
Remove the correct part Attach the covers (C, D) to Connect the appliance lat- Disconnect the parts (Ha), from the hinge cover (E). the lugs and the hinge erally to the kitchen furni- (Hb), (Hc) and (Hd). Make sure to remove the holes.
Place the small square on Press the part (Hd) on the the guide again and fix it part (Hb). with the screws supplied. Align the kitchen furniture door and the appliance door by adjusting the part Do a final check to make sure that: Important! If the ambient temperature is low (for example, in the Winter), the size of the gasket decreases.