hit counter script

Cisco SD208T-NA Administration Manual page 125

Administration guide
Table of Contents

Advertisement

Smartports
Auto Smartport
NOTE
Cisco Small Business 200 Series Smart Switch Administration Guide
If a device is aged out (no longer receiving advertisements from other
devices), the interface configuration is changed according to its Persistent
Status. If the Persistent Status is enabled, the interface configuration is
retained. If not, the Smartport Type reverts to Default.
Enabling Auto Smartport
Auto Smartport can be enabled globally in the
ways:
Enabled—This manually enables Auto Smartport and places it into
operation immediately.
Enable by Auto Voice VLAN—This enables Auto Smartport to operate if
Auto Voice VLAN is enabled and in operation. Enable by Auto Voice VLAN is
the default.
In addition to enabling Auto Smartport globally, you must enable Auto Smartport at
the desired interface as well. By default, Auto Smartport is enabled at all the
interfaces.
See
Voice VLAN
for more information on enabling Auto Voice VLAN
Identifying Smartport Type
If Auto Smartport is globally enabled (in the Properties page), and at an interface
Interface Settings
(in the
interface based on the Smartport type of the attaching device. Auto Smartport
derives the Smartport types of attaching devices based on the CDP and/or LLDP
the devices advertise.
If, for example, an IP phone is attached to a port, it transmits CDP or LLDP packets
that advertise its capabilities. After reception of these CDP and/or LLDP packets,
the switch derives the appropriate Smartport type for phone and applies the
corresponding Smartport macro to the interface where the IP phone attaches.
Unless Persistent Auto Smartport is enabled on an interface, the Smartport type
and resulting configuration applied by Auto Smartport is removed if the attaching
device(s) ages out, links down, reboots, or conflicting capabilities are received.
Aging out times are determined by the absence of CDP and/or LLDP
advertisements from the device for a specified time period.
page), the switch applies a Smartport macro to the
Properties
page in the following
10
126

Advertisement

Table of Contents
loading

Table of Contents