Table of Contents
Advertisement
Chapter 12
Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services
Select CiscoSecure Database from the Password Authentication drop-down menu.
Step 13
In the Password and Confirm Password fields, enter exactly the same password that you entered on the
Step 14
access point on the Wireless Services AP page.
Click Submit.
Step 15
Repeat
Step 16
Browse to the System Configuration page, click Service Control, and restart ACS to apply your entries.
Step 17
Figure 12-13
Figure 12-13
Configuring WDS Only Mode
WDS access points can operate in WDS only mode using the wlccp wds mode wds-only command.
After issuing this command and reloading, the access point starts working in the WDS only mode. In
WDS only mode, the dot11 subsystems are not initialized and the dot11 interface related commands
cannot be configured. In WDS only mode, the WDS supports up to 60 infrastructure access points and
up to 1200 clients. Use the no command to turn off WDS onlly mode. Use the show wlccp wds command
to display the working mode of the WDS access point.
To set the WDS access point to operate in both AP and WDS modes, use the no wlccp wds mode
wds-only command and use the write erase command to reload the access point immediately. After the
access point reloadss, the dot11 radio subsytems initialize. The access point and WDS associate directly
to wireless clients. In this mode, the WDS supports 30 infrastructure access points and 600 clients in
addition to 20 direct wireless client associations.
OL-14209-01
Step 10
through
Step 15
for each access point that uses the WDS device.
shows the System Configuration page.
ACS System Configuration Page
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
Configuring WDS
12-19
- Quick Links:
- Repeater Access Point
Hide quick links:
Advertisement
Table of Contents
