Indicators On 1300 Outdoor Access Point/Bridges; Normal Mode Led Indications - Cisco M10-RM Software Manual

Cisco ios releases 12.4(10b)ja and 12.3(8)jec

Hide thumbs Also See for M10-RM:

Table of Contents

Checking the Top Panel Indicators

Indicators on 1300 Outdoor Access Point/Bridges

If your access point/bridge is not associating with a remote bridge or access point, check the four LEDs

on the back panel. You can use them to quickly assess the unit's status. For information on using the

LEDs during the installation and alignment of the access point/bridge antenna, refer to the Cisco Aironet

1300 Series Outdoor Access Point/Bridge Mounting Instructions that shipped with your access

point/bridge.

During access point/bridge operation the LEDs provide status information as shown in

1300 Series Access Point/Bridge LED Indications

Cisco IOS Software Configuration Guide for Cisco Aironet Access Points

shows the access point/bridge LEDs.

Ethernet LED

Ethernet link is down or disabled.

Transmitting and receiving Ethernet packets.

Transmitting and receiving Ethernet errors.

Firmware error—disconnect and reconnect the power injector power

jack. If the problem continues, contact technical support for

Wireless Device Troubleshooting

Show Quick Links

Table of Contents

Aironet series