How To Configure A Dead Peer Detection Message - Cisco CRS-1 - Carrier Routing System Router Configuration Manual
Ios xr system security configuration guide
Hide thumbs
Also See for CRS-1 - Carrier Routing System Router:
- Administration manual (436 pages) ,
- Getting started manual (289 pages) ,
- Troubleshooting manual (264 pages)
Table of Contents
Advertisement
How to Configure a Dead Peer Detection Message
Command or Action
Step 9
set ipsec-profile profile-name
Example:
RP/0/RP0/CPU0:router(config-isa-prof-match)# set
ipsec-profile myprofile
Step 10
end
or
commit
Example:
RP/0/RP0/CPU0:router(config-isa-prof-match)# end
or
RP/0/RP0/CPU0:router(config-isa-prof-match)# commit
How to Configure a Dead Peer Detection Message
This task configures a keepalivedead peer detection (DPD) message.
SUMMARY STEPS
1.
2.
3.
Cisco IOS XR System Security Configuration Guide for the Cisco CRS-1 Router
SC-142
configure
crypto isakmp keepalive seconds retry-seconds [periodic | on-demand]
end
or
commit
Implementing Internet Key Exchange Security Protocol on Cisco IOS XR Software
Purpose
(Optional) Predefines the IPSec profile instance
when IKE negotiates for IPSec service associations
(SAs) for the traffic that is locally sourced or
terminated and the local endpoint is the IKE
responder.
Use the profile-name argument to set the name
•
of the IPSec profile.
•
Only available if you selected the local
Note
keyword earlier in this procedure.
Saves configuration changes.
When you issue the end command, the system
•
prompts you to commit changes:
Uncommitted changes found, commit them
before exiting (yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to
–
the running configuration file, exits the
configuration session, and returns the
router to EXEC mode.
Entering no exits the configuration session
–
and returns the router to EXEC mode
without committing the configuration
changes.
Entering cancel leaves the router in the
–
current configuration session without
exiting or committing the configuration
changes.
•
Use the commit command to save the
configuration changes to the running
configuration file and remain within the
configuration session.
OL-20382-01
Advertisement
Chapters
Table of Contents
