Brother BE-1204B Instruction Manual page 19
Cap frame device
Hide thumbs
Also See for BE-1204B:
- Instruction manual (262 pages) ,
- Maintenance schedule (9 pages) ,
- Supplement manual (2 pages)
Table of Contents
Advertisement
■ワイヤー張力調整 / Adjustment of the wire tension
[1]
[6]
1.
締めネジ[1]2 本をゆるめます。
1.
Loosen the two screws [1].
2.
テンション調整ネジ[3]の固定ナット[2]をゆるめ、テンション調整ネジ[3]でテンションを調整
します。
次の条件を満たすように調整してください。
・ ドライバーをツマミネジ[4]で固定した状態で、ボウシワクサッシ N[5]とワイヤー[6]の距離
が約 3mm
・ 図の位置にワイドセットワク C（0.45kg）を 1 個つり下げたときに、ボウシワクサッシ N[5]
とワイヤー[6]の距離が約 7mm
2.
Loosen the fixing nut [2] of the tension adjustment screw [3] to adjust the tension using the tension
adjustment screw [3].
Follow the conditions below for the adjustment:
* The clearance between the cap frame sash N [5] and the wire [6] should be about 3 mm with
the driver fixed by the thumb screw [4].
* When the wide set frame C (0.45 kg) is hung from the point illustrated, the clearance between
the cap frame sash N [5] and the wire [6] should be about 7 mm.
3.
調整が完了したら、締めネジ[1]と固定ナット[2]を確実に締めます。
3.
After the adjustment is completed, fasten the screw [1] and the fixing nut [2] firmly.
[2]
3mm
7mm
Electronic embroidery machine
[3]
0.45kg
[4]
[5]
W1430Q
3mm
W1431Q
17
Advertisement
Table of Contents
