Lubrication - Brother BAS-300G-484/484SF Instruction Manual
Instruction manual - english
Hide thumbs
Also See for BAS-300G-484/484SF:
- Manual de instrucciones (88 pages) ,
- Parts manual (80 pages) ,
- Instruction manual (42 pages)
Table of Contents
Advertisement
3-15. Lubrication
Do not connect the power cord until lubrication is complete.
If the foot switch is depressed by mistake, the sewing machine might start operating and injury could result.
Be sure to wear protective goggles and gloves when handling the lubricating oil and grease, so that they do not get into
your eyes or onto your skin. If the oil and grease get into your eyes or onto your skin, inflammation can result.
Furthermore, do not drink or eat the lubricating oil or grease. They may cause diarrhea or vomiting.
Keep the oil out of the reach of children.
The sewing machine should always be lubricated and the oil supply replenished before it is used for the first time, and also after
long periods of non-use.
Use only the lubricating oil <JX Nippon Oil & Energy Corporation Sewing Lube 10N; VG10> specified by Brother.
* If this type of lubricating oil is difficult to obtain, the recommended oil to use is <Exxon Mobil Essotex SM10; VG10>.
4655M
1. Fill the arm-side oil tank with oil.
2. Move the work clamp arm (1) as far as it will go to the right when looking from the front of the sewing machine, and then slide the
outer cover L (2) into the inner cover L (3) so that the lubrication hole in the bed is visible. Pour oil into the bed side oil tank
through this hole.
NOTE:
Be sure to fill the machine with oil when the oil level drops below the one-third level in the oil sight glasses (4) or (5). If the oil level
drops below the one-third level in the oil sight glasses (4) or (5), there is the danger that the sewing machine may seize during
operation.
4657M
3. Remove the bobbin case and add 2-3 drops of oil to the sliding parts (6) of the outer rotary hook and inner hook.
4. If using the needle cooler (7), fill it with silicon oil (100 mm
CAUTION
2
/s). (Refer to "4-2. Threading the upper thread".)
BAS-300G-484, BAS-300G-484 SF
3. INSTALLATION
4656M
4658M
18
- Quick Links:
- Table of Error Codes
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
