Page 1
ÖKO_FAVORIT 80850 i Dishwasher User Instructions...
Page 2
Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages of these user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance.
• Keep all packaging away from children. • Keep all detergents in a safe place out of children’s reach. • The water in your dishwasher is not suitable for drinking. If there are still remnants of detergent in the appliance, there is a risk of burns! •...
• Only use detergents specifically designed for use in domestic dish- washers. • Do not put any solvents in the dishwasher. There is a risk of an explo- sion! • The anti-flood system provides dependable protection against dam- age due to leaks.
Disposal Disposing of the Packaging Material Dispose of the dishwasher packaging material correctly. All the packag- ing materials used are harmless to the environment and can be recy- cled. • Plastic parts are marked with standard international abbreviations: –...
• The dishwasher's interior light is always switched on as long as the door of the appliance is open. To save energy you should therefore always close the door of the dishwasher after loading or removing...
Appliance Features and Control Panel Top Spray Arm Rubber Seal for Connecting the Water Feed to the Middle Spray Spray Arms Container for Salt Container for Rinse Aid Container for Detergent Inlet for Fan Assisted Drying Operating Instructions Rating Plate Filters Interior Lighting...
SPRAY ARM The FILTER indicator is intended to remind you to check the filters in the dishwasher from time to time and, if necessary, to clean it. The indicator illuminates at regular intervals, independent of the amount of soiling of the filters.
3. Fill with Rinse Aid Adjust the Water Softener To prevent the build up of scale on dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content water. For this reason the dishwasher is fitted with a water softener in which tap water from a hardness of 4 °d (German degree) is softened with the aid...
Page 12
Operating Instructions 1. The dishwasher must be switched off. 2. Press the signal tone and water softener buttons simultaneously and keep them pressed 3. Press the ON/OFF button. The LED indicators for the signal tone and water softener buttons flash.
Filling with Salt for the Water Softener Use only special salt for dishwashers. Never fill the salt container with any another type of salt (e.g. culinary salt) or dishwasher detergent, as this would irreparably damage the water softener. Prior to filling with salt, please check each time that you really do have a packet of dishwasher salt in your hand.
– Prior to using the dishwasher for the first time – When the RINSE AID indicator on the control panel is illuminated. The rinse aid container is on the inside of the dishwasher door. 1. Open the door 2. Turn the lid of the container ¼...
Setting the Audible Signal for the End of the Wash Programme The dishwasher can be set to exit an audible signal at the end of a wash cycle. 1. The dishwasher must be switched off. 2. Press the signal tone and water softener buttons simultaneously and keep them pressed.
– Dishes and items of cutlery must not lie inside one another, or cover each other are of limited suitability: • Only wash stoneware in the dishwasher if it is specifically marked as being dishwasher- safe by the manufacturer. • Glazed patterns may fade if machine washed frequently.
1. Place the grid insert on the cutlery rack 2. Place forks and spoons in the grid insert on the cutlery basket with the handle downwards. To make the removal of cutlery easier, on some dishwasher models it is possible to open the cutlery basket. Operating Instructions...
Page 18
Operating Instructions If you use the grid insert, it is not possible to open the cutlery basket. To ensure that the cutlery basket cannot open on removal from the appliance, you should always hold both parts of the two part handle. 1.
Load large and heavily soiled dishes in the lower rack. To ease the loading of large items at some dishwasher-models the two rows of prongs for the right-hand plate insert can be folded down: 1. Slightly lift the right plate insert.
Operating Instructions Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items.
Adjusting the Height of the Upper Rack With Raised Upper Rack With Lowered Upper Rack The height of the rack can also be adjusted when the rack is loaded. Lowering the Upper Rack: 1. Pull out the upper rack to the stop. 2.
Operating Instructions Filling with Detergent Use only dishwasher detergent. Fill with Detergent: – Prior to the start of a wash programme (not for the Pre Wash pro- gramme). The detergent is released into the wash water during the programme. Please observe the manufacturer’s dosing and storage recommenda- tions given on the detergent packaging.
Bio Wash Programmes and Concentrated Detergents Based on their chemical composition, dishwasher detergents can be split into two basic types: – Conventional, alkaline detergents with caustic components – Weak alkaline concentrated detergents with natural enzymes. The use of BIO wash programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes;...
Operating Instructions Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: Type of Dishes In Addition Type of Soiling • heavily to lightly soiled • dried leftovers Suitable Wash Pro- gramme: Programme Pre Wash Sequence...
Page 25
Types of Service Dishes with delicate glasses • lightly soiled Used dishes that are col- lected in the dishwasher and are to be washed at a later point in time. QUICK 40 °C PRE WASH Pre Wash Main Wash Rinsing...
Operating Instructions Starting the Wash Programme 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate. 2. Open the tap fully. 3. Shut the door. 4. Press the ON/OFF button The ON/OFF button indicator illuminates.
Hot steam may escape when the door is opened. Open the door care- fully. 1. Open the door of the dishwasher. The wash programme stops. 2. Shut the door. The wash programme continues. Cancelling the wash programme 1. Press the button for the wash programme in progress and keep it pressed.
Operating Instructions Setting or Changing the Delay Start Timer Using the delay start timer you can: 1. Press the ON/OFF button. 2. Press the DELAY TIMER button until the required delay (in hours) is flashing on the multi-display. 3. Press the button for the desired wash programme. The multi-display now displays the number of hours until the wash programme starts.
Dirty filters will give poor wash results. 1. Open the door, remove the lower rack. 2. The dishwasher filter system com- prises a coarse/fine filter, microfilter and a flat filter. Unlock the filter sys- tem using the handle on the microfil- ter, and remove.
What to do, if ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.
Page 32
WATER indica- tor is illuminated and 1 warning tone can be heard that is continually repeated: no water is run- ning into the dishwasher. The programme indicator for the selected programme is flashing, the multi-display is indicating the fault code (2...
– In the case of scale deposits on the dishes: the special salt container is empty or the water softener is incorrectly adjusted. Possible Cause The door of the dishwasher is not closed properly. Mains plug is not plugged in. Insert mains plug.
1-10 bar (=10-100 N/cm = 0.1-1.0 MPa) Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door on the right. 850 x 600 x 600 (H x B x D in mm) 54 Kg 820 –...
Notes for Test Institutes The salt container for the water softener and the rinse aid container must be completely full prior to the test. Test Standard: Comparative Programme: Full Load: Detergent Dosing: Half Load: Detergent Dosing: Rinse Aid Setting: Example Loading Arrangements: Top rack without cutlery tray Bottom rack with cutlery basket EN 5O 242...
INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted such that it is stable and level. • To compensate for unevenness in the floor and to match the height of the...
Free-Standing Appliances • can be set up as stand-alone without additional installation. If the dishwasher is set up next to a gas or coal cooker, a heat- insulating, non-flammable plate must be mounted between the dishwasher and the cooker, flush to the top edge of the work surface (depth 57.5 cm).
Page 38
(4) and remove the bracket at an angle to the rear (5). If the dishwasher is later used as a free-standing appliance, the original work surface must be re-mounted. The plinth on free-standing appliances is not adjustable.
Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the return of wash water into the drinking water system and comply with the appli- cable plumbing regulations. • The dishwasher should be connected to a cold water supply.
Installation and Connection Instructions Water drain Drain hose The drain hose must not be kinked, crushed or entangled. • Connecting the drain hose: – Maximum permitted height: 1 metre. – Minimum required height 30 cm above the lower edge of the machine.
Installation and Connection Instructions Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the safety valve immediately interrupts the sup- ply of water to the appliance and the drain pump switches on.
Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.
Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation.
Guarantee Conditions GUARANTEE CONDITIONS Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar doc- umentation.
SERVICE & SPARE PARTS If you wish to purchase spare parts or require an engineer, contact your local AEG Service Force Centre by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Centre covering your post code area. When you contact the Service Centre they will need the following information: Your name &...