Page 1
ÖKO_FAVORIT 80800 Dishwasher User Instructions...
Page 2
Dear customer, Please read these user instructions carefully. Above all please observe the safety instructions on the first few pages ofthese user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance.
OPERATING INSTRUCTIONS Safety Instructions The safety aspects of AEG electrical appliances comply with accepted technical standards and the German Appliance Safety Law. Neverthe- less, as a manufacturer we consider it our obligation to make you aware of the following safety information: Installation, Connection and Placing into Operation •...
• If the mains lead is damaged, or is to be replaced for a longer lead, the cable (obtainable from AEG customer service) must be changed by a service engineer authorised by AEG. • Never unplug the appliance by pulling on the cable, always pull the plug.
• Do not sit or stand on the open door, the appliance may tip over. • In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: switch off the fuse(s) or unscrew them.
Operating Instructions Economical and Ecological Dishwashing • Only connect the dishwasher to the hot water supply if your hot water is not electrically heated. • Ensure that the water softener is correctly adjusted. • Do not pre-rinse dishes under running water. •...
Operating Instructions Appliance Features and Control Panel Top Spray Arm Rubber Seal for Connecting the Water Feed to the Middle Spray Spray Arms Container for Special Salt Container for Rinse Aid Container for Detergent Inlet Rating Plate Filters Interior Lighting for Fan Assisted Drying...
Operating Instructions Control Panel Signal Tone Water Softener Button Button Control Panel The Control Panel comprises the ON/OFF switch (AAN/UIT; MARCHE/ARRET) and the programme buttons with LED indicators. Signal Tone Button: In addition to the wash programme printed on the front panel, this button can be used to set whether a signal tone is to indicate that a wash programme is finished.
Prior to using for the first time Prior to using for the first time, remove all the clips with which the dish racks are secured for transport. Then perform the following steps: 1. Adjust the water softener 2. Filling with Special Salt for the Water Softener 3.
Operating Instructions 1. The dishwasher must be switched off. 2. Press the signal tone and water softener buttons simultaneously and keep them pressed 3. Press the ON/OFF switch. The LED indicators for the signal tone and water softener buttons flash. 4.
Page 13
The water expelled by filling the salt container with special salt runs out of the salt container onto the base of the washing compartment. This is not a cause for concern, the water will be pumped out at the start of the next wash programme. 5.
Operating Instructions Filling with Rinse Aid Rinse aid ensures that your dishes gleam and are free from spots, and that you glasses are clear. Use only branded rinse aid for dishwashers. Never fill the rinse aid con- tainer with any another substance (e.g. concentrated vinegar). This would damage the appliance.
Adjusting Rinse Aid Dosing As the dishes are washed rinse aid is released from the dispenser into the wash water. The dose is factory set at 4, and can be adjusted from 1 to 6. Only change the setting if streaks, milky spots or dried on water marks are visible on glasses or crockery.
Operating Instructions In Daily Use • Is it necessary to refill with special salt or rinse aid? • Load cutlery and dishes into the dishwasher • Fill with dishwasher detergent • Select a wash programme suitable for the cutlery and dishes •...
– To avoid damage to glasses, they must not touch – Do not lay small objects (e.g. lids) in the cutlery rack Loading Cutlery Long, pointed items of cutlery are a hazard if placed in the cutlery basket, particularly to children (see Safety Instructions). They should therefore be placed in the upper rack.
Page 18
Operating Instructions If you use the grid insert, it is not possible to open the cutlery basket. To ensure that the cutlery basket cannot open on removal from the appliance, you should always hold both parts of the two part handle. 1.
Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower rack. To ease the loading of large items at some dishwasher-models the two rows of prongs for the right-hand plate insert can be folded down: 1.
Operating Instructions Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items.
Adjusting the Height of the Upper Basket With upper basket raised With upper basket lowered The height of the basket can also be adjusted when it is loaded. Depending on the model, your appliance is provided with one of the following types of upper basket: Lowering the Upper Basket: 1.
Operating Instructions Filling with Detergent Only use dishwasher detergent. Fill with detergent: – Prior to the start of a wash programme (not for the pre wash pro- gramme). The detergent is released into the wash water during the programme. Please observe the manufacturer's dosing and storage recommenda- tions as stated on the detergent packaging.
Bio Wash Programmes and Concentrated Detergents Based on their chemical composition, dishwasher detergents can be split into two basic types: – Conventional, alkaline detergents with caustic components – Weak alkaline concentrated detergents with natural enzymes. The use of BIO wash programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes;...
Operating Instructions Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: Type of Dishes In Addition Type of Soiling • heavily to lightly soiled • dried leftovers Suitable Wash Programme: Programme Pre Wash Main Wash Sequence...
Page 25
Type of Dishes Dinner Service and Cooking Utensils In Addition with non-temperature resistant dishes Type of • normally soiled Soiling Suitable Wash Programme: NORMAAL BIO; NORMAL 50 °C Programme Pre Wash Main Wash Sequence Rinsing Final Rinse Drying Consumption Figures: Duration 84 - 94 minutes Electricity...
Operating Instructions Starting the Wash Programme 1. Check that the dishes and cutlery are loaded into the dishwasher in such a manner that the spray arms are free to rotate. 2. Open the tap fully. 3. Shut the door. 4. Press the ON/OFF switch (AAN/UIT; MARCHE/ARRET) The ON/OFF switch indicator (AAN/UIT;...
Interrupting the wash programme by opening the door of the dish- washer Hot steam can escape when the door is opened. There is a risk of scold- ing! Open the door carefully. 1. Open the door of the dishwasher. The wash programme stops. 2.
Operating Instructions Setting or Changing the Start Delay Timer Using the start delay timer you can adjust when the wash programme is to begin within the next 19 hours. Setting the start delay timer: 1. Press the ON/OFF button (AAN/UIT; MARCHE/ARRET). 2.
Switching Off the Dishwasher Only switch the dishwasher off when the multi-display indicates “0“ for the remaining programme time and END (EINDE; FIN) is illuminated on the programme progress display. If the signal tone for the end of the washing programme is enabled, a continuous tone indicates the end of the programme for 10 seconds.
Operating Instructions Cleaning the Filter The filters in the base of the washing compartment are to a large extent self-cleaning. Nevertheless the filters should be checked and cleaned from time to time. Dirty filters will degrade the washing result. 1. Open the door, remove the lower rack.
What to do, when ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call in customer service to resolve one of the malfunctions listed here, or rectify an error made in the operation of the appliance, the customer service engineer’s visit is not free of charge, even during the period of guarantee.
Page 32
Operating Instructions Malfunction During a washing pro- gramme, the display SPRAY ARM (SPROIEARM; BRAS) lights up and a longer warn- ing tone can be heard at the same time. The display DOOR (DEUR; PORTE) lights up. The FILTER (ZEFF; FILTRE) display lights up.
...there are problems with the operation of the dish- washer. Malfunction The programme does not start. Rust spots are visible in the washing compart- ment. There is a whistling noise during washing. Dishwasher interior lighting does not work..the wash result is not satisfactory. The dishes are still dirty.
Page 34
Operating Instructions – The filter in the base of the washing compartment is dirty or incor- rectly positioned. – Detergent was not used or too little was used. – In the case of scale deposits on the dishes: the special salt container is empty or the water softener is incorrectly adjusted.
Technical Data Capacity: Permitted Water Pressure: Electrical Connection: Dishwasher: Free-Standing Appliances Dimensions: Max. Weight: Dishwashers that Can Be Integrated, Built-In Dishwashers Dimensions: Max. Weight: Dishwashers that Can Be Fully Integrated Dimensions: Max. Weight: ; This appliance conforms with the following EU Directives: –...
Operating Instructions Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table). Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see Programme Table).
INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted to ensure that it is stable and level. • To compensate for unevenness in the floor and to match the height of the appliance to that of surrounding units extend the threaded feet by unscrew- ing:...
Page 38
Installation and Connection Instructions • If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows: – Unscrew the screws (1) from the elbows on the back side. –...
Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations. • The dishwasher can be connected to cold and hot water supplies up to max.
In the case that you wish to hang the drain hose in a wash basin, use a detachable hose elbow. You can obtain this from AEG customer service under spare part number ET 646 069 190. 1. Fit the elbow to the drain hose.
Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the safety valve immediately interrupts the sup- ply of water to the appliance and the drain pump switches on. It is thus not possible for water to either leak or overflow.
Installation and Connection Instructions Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation;...
Garantiebepalingen GARANTIEBEPALINGEN WAARBORGVOORWAARDEN 1. WERKING: De waarborg treedt slechts in werking indien de aankoopfaktuur kan voorgelegd worden. 2. TOEPASSING Deze waarborg gaat in op het ogenblik van de levering aan de gebruiker. 3. DUUR VAN DE WAARBORG a) EEN JAAR op de onderdelen van het toestel, behalve 1) waterverwarmers –...
Page 45
Garantiebepalingen 8. VOOR HERSTELLINGEN zich wenden tot uw AEG verkorper of tot de door AEG Aanvaarde Herstelbedrijven. 9. Electrolux Home Products Belgium CONSUMER SERVICES AEG Bergensesteenweg, 719-1502 Lembeek. Tél. 02/363.04.44...
Service SERVICE In the section "What to do, if..." the most important sources of faults that you can rectify yourself are summarised. If, nevertheless, you call in customer service to resolve a problem listed in these instruction, or because of an error made in operating the appliance, the customer service engineer’s visit is not free of charge, even during the warranty period.