Cisco 4948 - Catalyst Switch Installation Manual page 59
Installation guide
Hide thumbs
Also See for 4948 - Catalyst Switch:
- Datasheet (18 pages) ,
- Product bulletin (4 pages) ,
- Datasheet (14 pages)
Table of Contents
Advertisement
Chapter 3
Installing the Switch
Figure 3-8
Figure 3-9
To install either an SFP or SFP+ transceiver, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to the ESD ground connector or a bare metal
Step 1
surface on your chassis.
Remove the SFP transceiver from its protective packaging.
Step 2
Note
Check the label on the SFP transceiver body to verify that you have the correct model for your network.
Step 3
Find the send (TX) and receive (RX) markings that identify the top side of the SFP transceiver.
Step 4
Note
Position the SFP transceiver in front of the socket opening.
Step 5
Note
Holding it as shown in
Step 6
place.
OL-21561-02
SFP Transceiver with an Actuator Button Latch
SFP Transceiver with a Bail-Clasp Latch
Do not remove the optical bore dust plugs until directed to do so later in the procedure.
On some SFP transceivers, the TX and RX marking might be replaced by arrowheads pointing
from the SFP transceiver connector (transmit direction or TX) and toward the connector (receive
direction or RX).
Different Cisco devices have different SFP socket configurations. Your Cisco device could have
either a latch-up or a latch-down orientation. Ensure that you are installing the SFP transceiver
in the correct orientation for your Cisco device.
Figure
3-10, insert the SFP into the socket until you feel the connector latch into
Catalyst 4948E and Catalyst 4948E-F Switch Installation Guide
Attaching the Interface Cables
3-17
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
