Brother BAS-326G PS Instruction Manual page 75

Direct drive programmable electronic pattern sewer

Hide thumbs Also See for BAS-326G PS:

Service manual (152 pages)

Manual de instrucciones (84 pages)

Parts manual (82 pages)

Table Of Contents

Table of Contents

Upper shaft motor-related errors

Code

Needle up stop position error.

E110

Turn the machine pulley until the point where the error display disappears.

Upper shaft did not stop at the needle up stop position when the sewing machine stopped.

E111

Turn the machine pulley until the point where the error display disappears.

Needle drop signal could not be detected.

E120

Turn off the power, and then check the synchronizer connection.

Thread trimming was not completed.

E121

Turn off the power, and then check if the cutting edges of the fixed knife and movable knife are damaged or worn.

Sewing machine motor stopped due to a problem, or synchronizer is faulty.

E130

Turn off the power, and then turn the machine pulley and check if the sewing machine has locked up.

Check that connectors P4 and P5 on the power supply motor P.C. board are properly connected.

Synchronizer is faulty.

E131

Turn off the power, and then check that connector P5 on the power supply motor P. C. board is properly connected.

Problem detected with sewing machine motor operation.

E132

Turn off the power, and then check that connector P4 on the power supply motor P.C. board is properly connected.

Sewing machine motor stopping position is incorrect.

E133

Turn off the power, and then check that connector P5 on the power supply motor P.C. board is properly connected.

Sewing machine motor is overheating, or temperature sensor is faulty.

Turn off the power, and then check the sewing machine motor.

E150

(When sewing data with a small number of stitches (15 stitches or less) is sewn repeatedly (short cycle operation),

the upper shaft motor may overheat and the "E150" error code may be generated.)

Feed mechanism-related errors

Code

X-feed motor home position cannot be detected.

Problem with X -feed motor or poor X home position sensor connection.

E200

Turn off the power, and then check that connector P10 on the PMD P.C. board and connector P20 on the main P.C.

board are properly connected.

X-feed motor stopped due to a problem.

E201

Turn off the power, and then check if there are any problems in the X-feed direction.

Problem with X-feed motor or Y-feed motor home position adjustment data.

E202

Re-adjust the home position.

X-feed motor stopped due to a problem during sewing.

E204

Turn off the power, and then check if there are any problems in the X-feed direction.

X-feed motor stopped due to a problem while moving to the sewing start position.

E205

Turn off the power, and then check if there are any problems in the X-feed direction.

X-feed motor stopped due to a problem during test feeding.

E206

Turn off the power, and then check if there are any problems in the X-feed direction.

X-feed motor stopped due to a problem during programming.

E207

Turn off the power, and then check if there are any problems in the X-feed direction.

Y-feed motor home position cannot be detected.

Problem with Y-feed motor or poor Y home position sensor connection.

E210

Turn off the power, and then check that connector P8 on the PMD P.C. board and connector P4 on the main P.C.

board are properly connected.

Y-feed motor stopped due to a problem.

E211