Table of Contents
Advertisement
4.7 Display Assembly
6. Lift up to remove the display assembly.
CAUTION: Be sure that the flexible cable has been disconnected from PJ3 on the
system board before removing the display assembly. An attempt to forcibly
remove the display assembly when the flexible cable is still connected to PJ3 may
result in a broken flexible cable.
Installing the Display Assembly
To install the display assembly, follow the steps below and refer to Figures 4-14 back through
4-11.
1. Connect the display flexible cable to PJ3 on the system board.
2. Place the display assembly onto the base.
3. Secure the metal cover with two thin-head M2.5 screws.
4. Close the display, turn the computer upside down, and secure the display with five
M2x14 silver screws.
5. Install the keyboard, optional memory module, HDD, optional PC card, and battery as
described in Sections 4.6 back through 4.2.
4-18
Figure 4-14 Display assembly removal
4 Replacement Procedures
Libretto 50CT/70CT Maintenance Manual
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
