Table of Contents
Advertisement
Client Adapter Software Procedures
Figure 9-4
Find the location of the new firmware in the Look in box.
Step 13
Click the firmware image file (*.img) so that it appears in the File name box at the bottom of the screen.
Step 14
Step 15
Click the Open button. A progress bar appears while the selected image is loaded into the client adapter's
Flash memory.
Step 16
Click OK when the "Firmware Upgrade Complete!" message appears. The OK button cannot be selected
until the process is complete or an error occurs. If an error occurs, refer to the
Chapter
Preventing the Driver from Upgrading the Firmware
The Automatically Load New Firmware When NDIS Driver Is Updated parameter on the Aironet Client
Utility Preferences screen affects the firmware that is bundled with the driver, not the firmware that is
included in the Install Wizard. This parameter controls whether the driver (whenever it loads) installs
the firmware with which it is bundled. (The driver loads each time you insert a client adapter or reboot
your computer.)
To complete this procedure, you must have used the Install Wizard to install ACU.
Note
The Automatically Load New Firmware When NDIS Driver Is Updated parameter is functionally
Note
equivalent to the Disable Firmware Checking parameter in the Install Wizard. The parameter that is set
last is the one that governs how the driver behaves. Refer to
Open ACU.
Step 1
Click the Preferences icon or select Preferences from the Options drop-down menu. The Aironet Client
Step 2
Utility Preferences screen appears (see
Cisco Aironet 340, 350, and CB20A Wireless LAN Client Adapters Installation and Configuration Guide for Windows
9-10
Load New Firmware Screen
10.
Chapter 3
Figure
9-5).
Chapter 9
Routine Procedures
"Error Messages"
section in
for additional information.
OL-1394-07
Advertisement
Table of Contents
Troubleshooting
