Table of Contents
Advertisement
Connecting and Using the CLI Console
Connecting and Using the CLI Console
For initial system configuration, use the command-line interface (CLI) console. As shown in the
following figure, the CLI console connects to the controller front-panel console port.
Figure 4
Do the following to connect the CLI console to the controller:
•
The Cisco Wireless LAN Controller end of the cable is female DB-9. The other end should be any kind
Note
of connector that plugs into your VT-100 terminal emulator (usually a laptop or palmtop computer).
•
Cisco 4400 Series Wireless LAN Controllers - Installation and Configuration Guide
14
CLI Console Connection to Controller
Use a null-modem serial cable to connect the CLI console to the controller console port.
Make sure the VT-100 terminal emulator (HyperTerminal, ProComm, minicom, tip, or other) is
configured for the following parameters:
9600 baud
–
8 data bits
–
no flow control
–
1 stop bit
–
no parity
–
Installation and Configuration
78-17157-01
Hide quick links:
Advertisement
Table of Contents
