Table of Contents
Advertisement
Collecting Required Tools and Information
Collecting Required Tools and Information
This section lists the tools and information that you should have before installing the controller.
Cisco Wireless LAN Controller Hardware
•
•
CLI Console
•
•
Local TFTP Server
This is required for downloading Operating System software updates. (Contact Cisco Technical
Assistance Center (TAC) for software updates.)
The Cisco WCS uses an integral TFTP server. This means that third-party TFTP servers cannot run on
Note
the same workstation as the Cisco WCS, because Cisco WCS and third-party TFTP servers use the same
communication port.
Initial System Configuration Information
Obtain the following initial configuration parameters from the wireless LAN/network planner:
The service-port interface and management interface MUST be on different subnets.
Note
Cisco 4400 Series Wireless LAN Controllers - Installation and Configuration Guide
6
Controller (ships with factory-supplied power cord and mounting hardware).
Network, Operating System Service network, and access point cables, as required.
VT-100 terminal emulator on CLI console laptop or palmtop.
Null modem serial cable to connect CLI console and Controller DB-9 console port.
System (Controller) name.
–
Administrative username and password. (Default Administrative username and password are
–
admin and admin, respectively.)
Service-Port Interface IP address configuration protocol (none or DHCP). Refer to
–
and
Configuration" for the Service port location.
If Service port configuration protocol =
–
and Service Port netmask.
Management Interface (DS Port, or Network Interface Port) IP address. Refer to
–
and
Configuration" for the Distribution System port locations.
Management Interface netmask.
–
Management Interface default router IP address.
–
, Service Port (front-panel Service port) IP address
none
Installation and Configuration
"Installation
"Installation
78-17157-01
Hide quick links:
Advertisement
Table of Contents
