Table of Contents
Advertisement
Chapter 2
Installing the Access Point
The 1250 series power injectors and 1250 series DC power modules are designed for an open-air
Caution
environment. To avoid damaging the units, you must not bind together multiple power injectors or power
modules.
Installing or Removing the Mounting Plate Latch
The mounting plate latch is located on the bottom of the access point
Figure 2-16
1
2
Installing the Mounting Plate Latch
Follow these steps to install the mounting plate latch:
Place the bottom of access point facing up and locate the two screw holes for the mounting plate latch
Step 1
(see
Place the mounting plate latch over the two screw holes.
Step 2
Screw two 3/16 in (0.476 cm) 4x40 screws into the screw holes.
Step 3
Removing the Mounting Plate Latch
Follow these steps to remove the mounting plate latch:
Place the bottom of access point facing up and locate the two screw holes for the mounting plate latch
Step 1
(see
Unscrew the two mounting plate screws and remove the mounting plate latch.
Step 2
OL-8247-03
Mounting Plate Latch
1
LOCK
OPEN
Bottom of access point
Mounting plate latch screws
Figure
2-16).
Figure
2-16).
Installing or Removing the Mounting Plate Latch
2
3
3
Mounting plate latch
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
(seeFigure
2-16).
2-23
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
