Table of Contents
Advertisement
Installing the Access Point to the Mounting Plate
Installing the Access Point to the Mounting Plate
There are two methods used to install the access point to the mounting plate:
•
•
When the mounting plate is not attached to a surface, the access point can be turned over to simplify the
installation process.
The mounting plate latch must be on the access point bottom plate to enable the mounting plate to be
installed (see the
The access point is shipped with the mounting plate latch and the mounting plate installed.
Note
Mounting Plate Not Attached to a Surface
When the mounting plate is not attached to surface, follow these steps to attach the mounting plate on
the access point:
Position your access point with the bottom plate facing you.
Step 1
Prior to attaching the access point to the mounting plate, ensure that the radio modules are completely
Step 2
inserted and both module latches are in the locked position (see
Line up the open ends of the four slots on the mounting plate with the access point foot pins. Ensure the
Step 3
mounting plate latch aligns with the mounting plate latch opening (see
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
2-24
Mounting plate attached to a surface
Mounting plate not attached to a surface
"Installing the Mounting Plate Latch" section on page
Chapter 2
Installing the Access Point
2-23).
Figure
2-24).
Figure
2-17).
OL-8247-03
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
