hit counter script

Advanced Setup For The Nme Ips - Cisco IPS-4255-K9 - Intrusion Protection Sys 4255 Installation Manual

Intrusion prevention system appliance and module installation guide for ips 7.0
Table of Contents

Advertisement

Chapter 10
Initializing the Sensor

Advanced Setup for the NME IPS

To continue with advanced setup for the NME IPS, follow these steps:
Session in to the NME IPS using an account with administrator privileges.
Step 1
router# service-module ids-sensor 1/0 session
Trying 10.1.9.1, 2322 ... Open
sensor login: cisco
Password: ********
Enter the
Step 2
Enter
Step 3
Specify the Telnet server status. You can disable or enable Telnet services. The default is disabled.
Step 4
Specify the web server port. The web server port is the TCP port used by the web server (1 to 65535).
Step 5
The default is 443.
Note
Enter
Step 6
You may receive a warning that Analysis Engine is initializing and you cannot modify the virtual sensor
configuration at this time. Press the space bar to receive this menu.
[0] Go to the command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration and exit setup.
Enter your selection[2]:
If you receive the warning that Analysis Engine is initializing, enter
far and exit setup. You can then reenter setup and press Enter until you are back to the interface and
virtual sensor menu.
Step 7
Enter
Modify interface/virtual sensor configuration?[no]: yes
Current interface configuration
Command control: Management0/1
Unassigned:
Monitored:
GigabitEthernet0/1
Virtual Sensor: vs0
Anomaly Detection: ad0
Event Action Rules: rules0
Signature Definitions: sig0
[1] Edit Interface Configuration
[2] Edit Virtual Sensor Configuration
[3] Display configuration
Option:
Enter
Step 8
OL-18504-01
command. The System Configuration Dialog is displayed.
setup
to access advanced setup.
3
The web server is configured to use TLS/SSL encryption by default. Setting the port to 80 does
not disable the encryption.
to modify the interface and virtual sensor configuration.
yes
to modify the virtual sensor configuration.
2
to edit the virtual sensor vs0 configuration.
2
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
Advanced Setup
to save your configuration thus
2
10-25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents