Table of Contents
Advertisement
Installing the Rail System Kit
Align the chassis side rails on the IPS 4270-20 with the slide assembly on both sides of the rack, release
Step 7
the blue slide tab (by either pulling the tab forward or pushing the tab back), and carefully push the
IPS 4270-20 in to place.
1
2
3
4
5
6
7
8
Keep the IPS 4270-20 parallel to the floor as you slide it into the rails. Tilting the IPS 4270-20 up or
Caution
down can damage the slide rails.
If you are using the cable management arm, install it before you connect and route any cables.
Step 8
Note
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0
4-24
Cisc o IPS
427 0 SER
IES
Intr usio
n Pre ven
tion Sen
sor
You may also need longer cables when the arm is installed (an extra length of around 3 feet is
required).
Chapter 4
Installing the IPS 4270-20
OL-18504-01
- Quick Links:
- Table of Contents
- How the Sensor Functions
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
