Table of Contents
Advertisement
Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers
Command
Router(config-if-atm-bundle)# inarp minutes
Router(config-if-atm-bundle)# broadcast
Router(config-if-atm-bundle)# ilmi manage
Router(config-if-atm-bundle)# oam retry
[up-count] [down-count] [retry-frequency]
Router(config-if-atm-bundle)# oam-bundle [manage]
[frequency]
Configuring VC Class Parameters to Apply to a Bundle
Use of a VC class allows you to configure a bundle by applying multiple attributes to it at one time
because you apply the class itself to the bundle. Use of a VC class allows you to generalize a parameter
across all VCs, after which (for some parameters) you can modify that parameter for individual VCs.
(See the
To configure a VC class to contain commands that configure VC members of a bundle when the class is
applied to that bundle, use the following command in vc-class configuration mode. To enter vc-class
configuration mode, use the vc-class atm command.
Command
Router(config-vc-class)# oam-bundle [manage]
[frequency]
In addition to the oam-bundle command, you can add the following commands to a VC class to be used
to configure a bundle: bump, precedence, mpls experimental, and protect commands. For more
information about these commands, refer to the
8-Port OC_3 STM-1 ATM Line Cards
Attaching a VC Class to a Bundle
To attach a preconfigured VC class containing bundle-level configuration commands to a bundle, use the
following command in bundle configuration mode:
Command
Router(config-if-atm-bundle)# class-bundle
vc-class-name
Parameters set through bundle-level commands contained in the VC class are applied to the bundle and
all its VC members. Bundle-level parameters applied through commands configured directly on the
bundle supersede those applied through a VC class.
Note that some bundle-level parameters applied through a VC class or directly to the bundle can be
superseded by commands that you directly apply to individual VCs in bundle-vc configuration mode.
For more information on bundle-vc configuration mode, see
following section.
"Applying Parameters to Individual VCs" section on page 30
How to Configure Layer 3 Terminated VCs on the 4-Port ATM ISE Line Card
Purpose
Configures the Inverse ARP time period for all VC bundle
members.
Enables broadcast forwarding for all VC bundle members.
Enables ILMI management.
Configures the VC bundle parameters related to OAM
management.
Enables end-to-end F5 OAM loopback cell generation and OAM
management for all VCs in the bundle.
Purpose
Enables end-to-end F5 OAM loopback cell generation and OAM
management for all VCs in the bundle.
ATM VC Bundle Management on Cisco 12000 Series
document.
Purpose
Configures a bundle with the bundle-level commands contained
in the specified VC class.
"Committing a VC to a Bundle"
for more information.)
Cisco IOS Release 12.0(27)S
in the
29
Advertisement
Table of Contents
Troubleshooting
