Table of Contents
Advertisement
How to Configure Layer 3 Terminated VCs on the 4-Port ATM ISE Line Card
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface atmslot/port.subifnum
{point-to-point | multipoint}
Example:
Router(config)# interface atm1/3.2
point-to-point
pvc [name] vpi/vci
Step 4
Example:
Router(config-subif)# pvc 10/50
Step 5
oam-pvc manage [frequency]
Example:
Router(config-if-atm-vc)# oam-pvc manage
Step 6
oam retry up-count down-count
retry-frequency
Example:
Router(config-if-atm-vc)# oam retry 3 5 1
Cisco IOS Release 12.0(27)S
12
Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Specify the new ATM subinterface to configure.
Specify an ATM PVC.
Enable OAM management.
(Optional) Specify OAM management parameters for
re-establishing and removing a PVC connection.
Use the up-count argument to specify the number of consecutive
end-to-end F5 OAM loopback cell responses that must be
received in order to change a PVC connection state to up. Use the
down-count argument to specify the number of consecutive
end-to-end F5 OAM loopback cell responses that are not received
in order to tear down a PVC. Use the retry-frequency argument to
specify the frequency (in seconds) at which end-to-end F5 OAM
loopback cells should be transmitted when a change in
UP/DOWN state is being verified. For example, if a PVC is up
and a loopback cell response is not received after the frequency
(in seconds) specified using the oam-pvc command, then
loopback cells are sent at the retry-frequency to verify whether or
not the PVC is down.
Advertisement
Table of Contents
Troubleshooting
