Table of Contents
Advertisement
Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers
Command or Action
Step 10
set mpls experimental mpls-exp-value
Example:
Router(config-pmap-c)# set mpls experimental 4
Step 11
police rate pcr cps delay-tolerance cdvt
conform-action transmit exceed-action drop
Example:
Router(config-pmap-c)# police rate 500000 cps
delay-tolerance 1000 conform-action transmit
exceed-action drop
Step 12
service-policy child-vbr1
Example:
Router(config-pmap-c)# service-policy
child-vbr1
After you configure the policy map, you must attach it to a PVC using the service-policy command as
described in the
Configuring VBR.2 Policing
This task describes how to configure VBR.2 policing.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
"Attaching a Service Policy to a PVC" section on page
enable
configure terminal
class-map match-all clp0
match not atm clp
exit
policy-map child-vbr1
class clp0
police rate scr cps atm-mbs mbs cells conform-action transmit exceed-action drop
exit
exit
policy-map vbr2
class class-default
set mpls experimental mpls-exp-value
policy rate pcr cps delay-tolerance cdvt conform-action transmit exceed-action drop
service-policy child-vbr1
How to Configure AToM VCs on the 4-Port ATM ISE Line Card
Purpose
(Optional) Specifies the value used to set the MPLS EXP
bits defined by the policy map. Valid values are numbers
from 0 to 7.
Specifies a maximum bandwidth usage by a traffic class
through the use of a token bucket algorithm. For a
description of the conform-action and exceed-action
keywords, see
Table 5 on page
Attaches the child service policy to the VBR1 policy map.
Cisco IOS Release 12.0(27)S
16.
72.
67
Advertisement
Table of Contents
Troubleshooting
