5.X Software Release Examples - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual
Intrusion prevention system appliances and modules 5.0
Hide thumbs
Also See for IPS-4240-K9 - Intrusion Protection Sys 4240:
- Installation instructions manual (14 pages) ,
- Getting started manual (12 pages)
Table of Contents
Advertisement
IPS Software Versioning
Service packs are cumulative following a base version release (minor or major). Service packs are used
for the release of defect fixes with no new enhancements. Service packs contain all service pack fixes
since the last base version (minor or major) and the new defect fixes being released. Service packs
require the minor version.
Signature updates are cumulative and increment by one with each new release (for example, S145, S146,
S147). Signature updates include every signature since the initial signature release (S1) in addition to
the new signatures being released. Signature updates require the minimum version listed in the filename.
To install the most recent signature update, you must have the most recent minor version. Service packs
are dependent on the most recent minor version, which is dependent on the most recent major version.
For a table listing the types of files with examples of filenames and corresponding software releases, see
Note
5.x Software Release Examples, page
In addition there are system image files for the IDS-4215, IPS-4240, IPS-4255, NM-CIDS, IDSM-2,
AIP-SSM-10, and AIP-SSM-20, recovery partition files for all sensors, and a maintenance partition file
for IDSM-2:
•
•
•
5.x Software Release Examples
Table 10-1
accompany the software files for detailed instructions on how to install the files. For instructions on how
to access these files on Cisco.com, see
Table 10-1
Release
Signature update
Service pack
Minor version
Major version
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
10-4
System image files (IDS-4215, IPS-4240, IPS-4255 NM-CIDS, IDSM-2, AIP-SSM-10, and
AIP-SSM-20)—Full IPS application and recovery image used for reimaging an entire sensor.
Recovery partition image file—A recovery partition image file is a partition on the sensor that
contains a full IPS application image to be used for recovery.
Maintenance partition image file (IDSM-2 only)—A maintenance partition image file is used to
reimage the maintenance partition of IDSM-2. Maintenance partition files are released when new
major or minor versions of the maintenance partition are released. Maintenance partition image files
are not released for service packs to the maintenance partition. A service pack may be released to
address defects identified in existing maintenance partition images, but new maintenance partition
images are not produced for subsequently released service packs.
Note
The maintenance partition image file does not contain a signature designator.
lists platform-independent IDS 5.x software release examples. Refer to the readmes that
Platform-Independent Release Examples
Target Frequency Identifier
1
Weekly
2
Semi-annually
or as needed
3
Annually
4
Annually
10-4.
Obtaining Cisco IPS Software, page
Supported
Platform
sig
All
sp
All
min
All
maj
All
Chapter 10
Obtaining Software
10-1.
Example File Name
IPS-sig-S70-minreq-5.0-1.pkg
IPS-K9-sp-5.0-2.pkg
IPS-K9-min-5.1-1.pkg
IPS-K9-maj-5.0-1.pkg
78-16124-01
Hide quick links:
Advertisement
Table of Contents
