Table of Contents
Advertisement
Replacing or Installing Components
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Step 14
Power up, connect the terminal to the console port, and configure the secondary fabric interconnect as
descrubed in the Configuration guide for your software release. The procedure is in the "System
Configuration" section, "Configuring the Fabric Interconnects" chapter.
Note
A setup utility launches automatically the first time you access the system and guides you through the
basic configuration. For instructions on how to configure the system and check module connectivity, see
the
Cisco UCS Manager CLI Configuration Guide
Replacing or Installing Components
This section describes how to replace and install components, and contains the following topics:
•
•
•
•
Caution
To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by
the carrier edges only.
Replacing or Installing Expansion Modules
You can either replace existing expansion modules or install new ones where expansion modules are not
installed. If you are replacing a module, you need to follow the procedures that explain how to remove
and install expansion modules. If you are installing an expansion module, you need to follow only the
installation procedure.
To prevent ESD damage, wear grounding wrist straps during these procedures. When handling the
Caution
expansion modules, handle them only on their carrier edges.
Install the Cisco UCS 6100 Series Fabric Interconnect chassis in the rack before installing expansion
Note
modules. For information about installing the chassis, see the
in a Cabinet or Rack" section on page
This section includes the following topics:
•
•
Cisco UCS 6100 Series Fabric Interconnect Hardware Installation Guide
2-22
Replacing or Installing Expansion Modules, page 2-22
Replacing or Installing Power Supplies, page 2-24
Replacing a Fan Module, page 2-27
Removing a Cisco UCS 6120XP, page 2-29
Removing an Expansion Module, page 2-23
Installing an Expansion Module, page 2-24
Chapter 2
Installing the Cisco UCS 6100 Series Fabric Interconnect
or
theCisco UCS Manager GUI Configuration Guide
"Installing the Cisco UCS 6120XP Chassis
2-6.
.
OL-20036-02
Hide quick links:
Advertisement
Table of Contents
