Table of Contents
Advertisement
Installing or Replacing an AC Power Supply Module
Warning
If a Cisco external power system is not connected to the switch, install the provided connector cover on the
back of the switch.
Statement 386
Installing or Replacing an AC Power Supply Module
Procedure
Step 1
Turn off the power at its source.
Step 2
Remove the power cord from the power cord retainer.
Step 3
Remove the power cord from the power connector.
Step 4
Press the release latch at the right side of the power supply module inward and slide the power supply out.
Caution
Warning
Step 5
Insert the new power supply into the power-supply slot, and gently push it into the slot. When correctly
inserted, the power supplies (excluding the power cord retainer) are flush with the switch rear panel.
Figure 30: Inserting the AC-Power Supply in the Switch
Step 6
(Optional) Install the power cord retainer as follows:
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
46
Do not leave the power-supply slot open for more than 90 seconds while the switch is operating.
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Installing a Power Supply Unit
- Quick Links:
- Front Panel Components
Hide quick links:
Advertisement
Table of Contents
