Cisco AS5350XM Configuration Manual page 35
Universal gateways software configuration guide
Hide thumbs
Also See for AS5350XM:
- Installation manual (98 pages) ,
- Quick start manual (69 pages) ,
- Installation manual (104 pages)
Table of Contents
Advertisement
Understanding Basic Hardware Architecture and Cisco IOS Software
Command
Step 1
Router> enable
Password: password
Router#
Step 2
Router#
Enter configuration commands, one per line. End
with CNTL/Z.
Router(config)#
Step 3
Router(config)# controller t1 1/?
<0-1>
Router(config)# controller t1 1/0
Step 4
Router(config-controller)# ?
Controller configuration commands:
cablelength
channel-group
default
description
ds0
ds0-group
exit
fdl
framing
help
linecode
loopback
no
pri-group
shutdown
Step 5
Router(config-controller)# ds0-group ?
Step 6
Router(config-controller)# ds0-group 1 ?
config terminal
Controller port number
Specify cable length for a
DS1 link
Specify timeslots to
channel-group mapping for an
interface
Set a command to its defaults
Controller specific
description
ds0 commands
Replacement of cas-group
Configure group of timeslots
to a particular signaling
type
Exit from controller
configuration mode
Specify the FDL standard for
a DS1 data link
Specify the type of Framing
on a DS1 link
Description of the
interactive help system
Specify the line encoding
method for a DS1 link
Put the entire T1 line into
loopback
Negate a command or set its
defaults
Configure the specified
timeslots for PRI
Shut down a DS1 link (send
Blue Alarm)
<0-23>
Channel number
timeslots
List of timeslots in the ds0-group
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Exploring Cisco IOS Software
Purpose
Enters enable mode. Enters the
password. You are in enable mode when
the prompt changes to
Router#
Enters global configuration mode. You
are in global configuration mode when
the prompt changes to
Router(config)#
Specifies the T1 controller that you want
to configure using the controller T1
number global configuration command.
Displays controller configuration
commands.
Displays the options for the ds0-group
controller configuration command. This
command is used to configure the
channel-associated signaling on a T1
controller.
Displays the only command (timeslots)
available in ds0-group 1.
.
.
7
- Quick Links:
- Using the Cli
- Managing Ports
Hide quick links:
Advertisement
Table of Contents
