Cisco WS-C3560-48PS-S Hardware Installation Manual page 106
Catalyst 3560 series switch
Hide thumbs
Also See for WS-C3560-48PS-S:
- Product manual (20 pages) ,
- Software configuration manual (892 pages)
Table of Contents
Advertisement
Connecting to DC Power
Figure C-6
0.25 inch (6.3 mm) ± 0.02 inch (0.5 mm)
Insert the exposed wire of one of the four DC-input power source wires into the terminal block plug, as
Step 5
shown in
extend from the terminal block.
An exposed wire lead from a DC-input power source can conduct harmful levels of electricity. Be sure
Warning
that no exposed portion of the DC-input power source wire extends from the terminal block plug.
Statement 122
Figure C-7
Use a ratcheting torque screwdriver to torque the terminal block captive screw (above the installed wire
Step 6
lead) to 4.5 lbf-in. (72 ozf-in.), as shown in
Do not overtorque the terminal-block captive screws. The recommended maximum torque is 4.5 lbf-in.
Caution
(72 ozf-in.)
Catalyst 3560 Switch Hardware Installation Guide
C-6
Stripping the DC-Input Power Source Wire
Figure
C-7. Make sure that you cannot see any wire lead. Only wire with insulation should
Inserting Wires in the Terminal Block Plug
Return
Feed A
Negative
Return
Feed B
Negative
Figure
C-8.
Appendix C
Connecting to DC Power
OL-6337-07
Hide quick links:
Advertisement
Table of Contents
