Connecting To 1000Base-T Sfp Modules - Cisco WS-C3560-48PS-S Hardware Installation Manual
Catalyst 3560 series switch
Hide thumbs
Also See for WS-C3560-48PS-S:
- Product manual (20 pages) ,
- Software configuration manual (892 pages)
Table of Contents
Advertisement
Connecting the Switch to Compatible Devices
•
If necessary, reconfigure and restart the switch or target device.
Step 5
Connecting to 1000BASE-T SFP Modules
To prevent ESD damage, follow your normal board and component handling procedures.
Caution
When connecting to a 1000BASE-T device, use a four twisted-pair, Category 5 or higher cable.
Note
The auto-MDIX feature is enabled by default. For configuration information for this feature, see the
switch software configuration guide or the switch command reference.
Step 1
Insert one end of the cable into the SFP module port (see
workstations, and routers, insert a four twisted-pair, straight-through cable in the RJ-45 connector. When
connecting to switches or repeaters, insert a four twisted-pair, crossover cable.
Figure 2-20
1
Step 2
Insert the other cable end in an RJ-45 connector on a target device.
Observe the port status LED.
Step 3
•
•
Catalyst 3560 Switch Hardware Installation Guide
2-22
If the LED is off, the target device might not be turned on, there might be a cable problem, or there
might be problem with the adapter installed in the target device. See
for solutions to cabling problems.
Connecting to a 1000BASE-T SFP Module
4 0
4 1
4 2
4 3
4 4
4 5
4 6
4 7
4 8
47 X
48 X
1
RJ-45 connector
The LED turns green when the switch and the target device have an established link.
The LED turns amber while the STP discovers the network topology and searches for loops. This
process takes about 30 seconds, and then the port LED turns green.
Chapter 2
Figure
C a t a ly s t
3 5 6 0
S E R IE S
P o E - 4 8
1
3
2
4
Switch Installation (24- and 48-Port Switches)
Chapter 4, "Troubleshooting,"
2-20). When connecting to servers,
OL-6337-07
Hide quick links:
Advertisement
Table of Contents
