Mounting The Switch On A Wall - Cisco WS-C3560-48PS-S Hardware Installation Manual
Catalyst 3560 series switch
Hide thumbs
Also See for WS-C3560-48PS-S:
- Product manual (20 pages) ,
- Software configuration manual (892 pages)
Table of Contents
Advertisement
Installing the Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure the switch is attached securely to wall studs or
to a firmly attached plywood mounting backboard. Mount the switch with the front panel facing up, as
shown in
See the
facing down.
Read the wall-mounting instructions carefully before beginning installation. Failure to use the
Warning
correct hardware or to follow the correct procedures could result in a hazardous situation to people
and damage to the system. Statement 378
Figure 2-12
1
After the switch is mounted in the rack:
1.
2.
3.
Catalyst 3560 Switch Hardware Installation Guide
2-14
Figure
2-12.
"Wall-Mounting" section on page 2-12
Mounting the Switch on a Wall
1
User-supplied screws
Power on the switch. See the
Connect to a 10/100 or 10/100/1000 port, and run Express Setup. See the Catalyst 3560 Switch
Getting Started Guide for instructions. To use the CLI setup program, see
"Configuring the Switch with the CLI-Based Setup Program."
Connect to the front-panel ports.
Chapter 2
for the switches that can also mount with the front panel
"Verifying Switch Operation" section on page
Switch Installation (24- and 48-Port Switches)
1
2-6.
Appendix D,
OL-6337-07
Hide quick links:
Advertisement
Table of Contents
