Table of Contents
Advertisement
24-Port 10/100 + 2-Port Gigabit Switch with Webview and Power over Ethernet
IP Configuration
The IP Configuration screen displays four menu choices: IP Address Settings, HTTP, SNMP and Network
Configuration.
IP Address Settings
The IP Address Settings screen allows you to set the IP information for the Switch.
Figure 4-14: IP Configuration
IP Address. This sets the Switch's IP Address. The default setting is 192.168.1.254.
Subnet Mask. This combined with the IP Address defines the Switch's network address.
Default Gateway. This defines the IP Address for the default gateway of the network.
Management VLAN. Set the ID number of the Management VLAN. This is the only VLAN through which you can
gain management access to the Switch. By default, all ports on the Switch are members of VLAN 1, so a
management station can be connected to any port on the Switch. However, if other VLANs are configured and you
change the Management VLAN, you may lose management access to the Switch. In this case, you should
reconnect the management station to a port that is a member of the Management VLAN.
IP Mode. Choose to have either a user defined IP address or to have it assigned by DHCP or BOOTP.
Figure 4-15: IP Address Configuration Screen
HTTP
The HTTP screen allows you to set the Hyper Text Transfer Protocol information for the Switch.
HTTP Server. Enable or Disable the Switch's HTTP server function.
HTTP Server port. Set the TCP port which HTTP packets are sent and received from.
HTTPS Server. Enable or Disable the Secure HTTP server function of the Switch.
HTTPS Server port. Set the TCP port witch HTTPS packets are sent and received from.
Figure 4-16: HTTP
16
Chapter 4: Configuration using the Console Interface
Configuring the Switch through the Console Interface
Hide quick links:
Advertisement
Table of Contents
