Table of Contents
Advertisement
Chapter 3
Configuring with the Command-Line Interface
Command
Step 7
Router(config-if)# exit
Step 8
Router(config-if)# Ctrl-z
Router#
Saving Configuration Changes
To prevent the loss of the Cisco VG224 configuration, save it to NVRAM:
Command
Step 1
Router> enable
Password: password
Router#
Step 2
Router# copy running-config startup-config
Step 3
Router(config-if)# Ctrl-z
Router#
%SYS-5-CONFIG_I: Configured from console by
console
Where to Go Next
At this point you can proceed to the following:
•
•
OL-5005-01
The Cisco IOS software configuration guide and command reference publications for more
advanced configuration topics. These publications are available on Cisco.com or on the
Documentation CD-ROM, or you can order printed copies.
Cisco System Error Messages, Release 12.3(4)T, and Cisco Debug Command Reference, Release
12.3(4)T provide troubleshooting information. For these and other documents, see
Documentation, page
x.
Purpose
Exits back to global configuration mode.
Repeat Step 4 through Step 6 if your Cisco VG224
has more than one interface that you need to
configure.
When you finish configuring interfaces, returns to
enable mode.
Purpose
Enters enable mode. Enter the password.
You have entered enable mode when the prompt
changes to
.
Router#
Saves the configuration changes to NVRAM so
that they are not lost during resets, power cycles,
or power outages.
Returns to enable mode.
This message is normal and does not indicate an
error.
Cisco VG224 Voice Gateway Software Configuration Guide
Saving Configuration Changes
Obtaining
3-5
Advertisement
Table of Contents
