Table of Contents
Advertisement
Completing the Configuration
•
Fast Ethernet Interface Configuration
This section contains a sample configuration for the Fast Ethernet interface. Enter the values appropriate
for your Cisco VG224 and network. The messages you see may vary.
Do you want to configure FastEthernet0/0 interface [yes]:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]:
Configure IP on this interface? [no]: yes
IP address for this interface: 6.0.0.1
Number of bits in subnet field [0]:
Class A network is 6.0.0.0, 0 subnet bits, mask is /8
Configure IPX on this interface? [yes]:
Completing the Configuration
When you have provided all the information prompted for by the setup command facility, the
configuration appears.
For sample configurations, see
Note
To complete your configuration, do the following:
A setup command facility prompt asks if you want to save this configuration, with the following options:
Step 1
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you answer 0, the configuration information you entered is not saved, and you return to the Cisco
VG224 enable prompt (
If you answer 1, you return to setup without saving the configuration.
If you answer 2, the configuration is saved and you are returned to the user EXEC prompt
Step 2
When the messages stop appearing on your screen, press Return to get the
Step 3
The
completed a basic Cisco VG224 configuration. However, this is not a complete configuration. At this
point you have two choices:
•
Cisco VG224 Voice Gateway Software Configuration Guide
2-6
Fast Ethernet Interface Configuration
IPX network number [1]:
Need to select encapsulation type
[0] sap (IEEE 802.2)
[1] snap (IEEE 802.2 SNAP)
[2] arpa (Ethernet_II)
[3] novell-ether (Novell Ethernet_802.3)
Enter the encapsulation type [2]:
Router#
prompt indicates that you are now at the command-line interface (CLI) and you have just
Router>
Run the setup command facility again and create another configuration. Enter the following:
Router> enable
Password: password
Router# setup
Appendix A, "Cisco VG224 Configuration Example."
). Type setup to return to the System Configuration Dialog.
Chapter 2
Using the setup Command
(Router>)
prompt.
Router>
OL-5005-01
.
Advertisement
Table of Contents
