Reactivating A Spa - Cisco ASR1004 - ASR 1004 Modular Expansion Base Hardware Installation Manual
Aggregation services routers sip and spa
Hide thumbs
Also See for ASR1004 - ASR 1004 Modular Expansion Base:
- Quick start manual (39 pages) ,
- Install manual (32 pages) ,
- Software configuration manual (462 pages)
Table of Contents
Advertisement
Chapter 5
Installing and Removing a SIP
To deactivate a SPA and all of its interfaces prior to removal of the SPA, use one of the following
commands in global configuration mode:
Command or Action
Router(config)# hw-module subslot
slot-number/subslot-number shutdown [powered |
unpowered]
Router(config)# hw-module subslot
slot-number/subslot-number {reload | stop | start}
For more information about chassis slot and SIP subslot numbering, refer to the
Subslots for SIPs and SPAs" section on page
Reactivating a SPA
You do not need to reactivate a SPA after an OIR of either the SIP or a SPA if you did not deactivate
Note
the SPA prior to removal when using the hw-module subslot command in global configuration mode.
If the Cisco ASR 1000 Series Router is running, then the SPAs automatically start upon insertion into
the SIP or with insertion of a SIP into the Cisco ASR 1000 Series Router.
If you deactivate a SPA using the hw-module subslot stop command and need to reactivate it without
performing an OIR, you must use the hw-module subslot start command to reactivate the SPA and its
interfaces.
OL-14126-12
Purpose
Deactivates the SPA in the specified slot and subslot of the SIP,
where:
slot-number—Specifies the chassis slot number where the SIP
•
is installed.
•
subslot-number—Specifies the subslot number on a SIP where
a SPA is installed.
•
shutdown—Shuts down the specified SPA.
•
powered—(Optional) Shuts down the SPA and all of its
interfaces, and leaves them in an administratively down state
with power enabled. This is the default state.
unpowered—(Optional) Shuts down the SPA and all of its
•
interfaces, and leaves them in an administratively down state
without power.
Deactivates the SPA in the specified slot and subslot of the SIP,
where:
slot-number—Specifies the chassis slot number where the SIP
•
is installed.
subslot-number—Specifies the subslot number on a SIP where
•
a SPA is installed.
reload—Stops and restarts the specified SPA.
•
stop—Stops the specified SPA.
•
start—Starts the specified SPA.
•
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
2-3.
Online Insertion and Removal
"Identifying Slots and
5-7
Advertisement
Table of Contents
Troubleshooting
