Configuring Tdm Cross-Connect - Cisco 2431 - IAD Router Software Configuration Manual
Integrated access devices
Hide thumbs
Also See for 2431 - IAD Router:
- System message manual (106 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
Configuring T1/E1 Interfaces
Command or Action
Step 12
exit
Example:
Router(config-if)# exit
Step 13
Ctrl-z
Example:
Router#
Example
The following example shows typical DS0 groups configuration:
controller T1 0/0
channel-group 0 timeslots 1-20 speed 64
ds0-group 1 timeslots 21-24 type fxo-loopstart
!
voice-port 0/0:1
!
voice-port 0/1/0 << FXS
!
dial-peer voice 1 pots
description calls to PSTN - dial 9 from FXS
destination-pattern 9T
port 0/0:1
!
dial-peer voice 2 pots
description calls to Analog phone from PSTN
destination-pattern 4083333333
port 0/1/0
0
Configuring TDM Cross-Connect
For multiflex trunk interfaces using the time-division multiplexing (TDM) connect function, you can use
the connect command to cross-connect (1) two TDM groups from two controllers, or (2) an analog FXS
port and a DS0 group on a T1. Cross-connecting is done differently for data and voice, as shown in the
following procedures:
•
•
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
3-16
Configuring TDM to TDM
Configuring TDM to Analog Voice Port
Chapter 3
Configuring with the Command-Line Interface
Purpose
Exits to global configuration mode.
Returns to enable mode when you finish configuring
interfaces.
OL-4306-03
Hide quick links:
Advertisement
Table of Contents
