Ipsec Setup - Cisco RV016 User Manual
10/100 16-port vpn router business series
Hide thumbs
Also See for RV016:
- Administration manual (199 pages) ,
- Quick start manual (13 pages) ,
- Datasheet (4 pages)
Table of Contents
Advertisement
Chapter 4
NOTE:
The Local Security Group Type you select
should match the Remote Security Group Type
selected on the remote computer at the other
end of the tunnel.
After you have selected the Local Security Group Type, the
settings available on this screen may change, depending
on which selection you have made.
IP
Only the computer with a specific IP address will be able
to access the tunnel.
Local Security Group Type > IP
IP address
Enter the appropriate IP address. The default
IP is 192.168.1.0.
Subnet
The default is Subnet. All computers on the local subnet
will be able to access the tunnel.
Local Security Group Type > Subnet
IP address
Enter the IP address. The default is
192.168.1.0.
Subnet Mask
Enter the subnet mask. The default is
255.255.255.0.
IP Range
Specify a range of IP addresses within a subnet that will be
able to access the tunnel.
Local Security Group Type > IP Range
IP range
Enter the range of IP addresses. The default is
192.168.1.0~254.
Remote Client Setup
Remote Client
Select the type you want to use: Domain Name(FQDN),
E-mail Addr.(USER FQDN), or Microsoft XP/2000 VPN
Client. Follow the instructions for the type you want to
use.
10/100 16-Port VPN Router
Advanced Configuration
Domain Name(FQDN)
The default is Domain Name(FQDN).
Remote Client > Domain Name(FQDN)
Domain Name
Enter the Fully Qualified Domain Name
(FQDN), which is the host name and domain name for
a specific computer on the Internet. When the remote
computer requests to create a tunnel with the Router, the
Router will work as a responder.
E-mail Address(UserFQDN)
Remote Client > E-mail Address(UserFQDN)
E-mail address
Enter the e-mail address of the user
FQDN.
Microsoft XP/2000 VPN Client
Dynamic IP users, such as PPPoE or DHCP users, who use
the Microsoft VPN client software, can use this option.
(The Microsoft VPN client software does not support
Aggressive mode and FQDN or User FQDN ID options.)
Remote Client > Microsoft XP/2000 VPN Client
IPSec Setup
In order for any encryption to occur, the two ends of a
VPN tunnel must agree on the methods of encryption,
decryption, and authentication. This is done by sharing
a key to the encryption code. For key management, the
default mode is IKE with Preshared Key.
Keying Mode
Select IKE with Preshared Key or Manual.
Both ends of a VPN tunnel must use the same mode of
key management. After you have selected the mode, the
settings available on this screen may change, depending
on the selection you have made. Follow the instructions
for the mode you want to use. (Manual mode is available
for VPN tunnels only, not group VPNs.)
IKE with Preshared Key
IKE is an Internet Key Exchange protocol used to negotiate
key material for Security Association (SA). IKE uses the
Preshared Key to authenticate the remote IKE peer.
Phase 1 DH Group
Phase 1 is used to create the SA. DH
(Diffie-Hellman) is a key exchange protocol used during
Phase 1 of the authentication process to establish pre-
47
Hide quick links:
Advertisement
Table of Contents
